diff options
Diffstat (limited to 'arch/arm/mach-omap2/board-apollon.c')
| -rw-r--r-- | arch/arm/mach-omap2/board-apollon.c | 13 |
1 files changed, 8 insertions, 5 deletions
diff --git a/arch/arm/mach-omap2/board-apollon.c b/arch/arm/mach-omap2/board-apollon.c index 6c6ba172cdf6..2db6b732b084 100644 --- a/arch/arm/mach-omap2/board-apollon.c +++ b/arch/arm/mach-omap2/board-apollon.c @@ -166,8 +166,8 @@ static struct omap_uart_config apollon_uart_config __initdata = { static struct omap_mmc_config apollon_mmc_config __initdata = { .mmc [0] = { - .enabled = 0, - .wire4 = 0, + .enabled = 1, + .wire4 = 1, .wp_pin = -1, .power_pin = -1, .switch_pin = -1, @@ -234,17 +234,17 @@ static void __init apollon_sw_init(void) set_irq_type(OMAP_GPIO_IRQ(SW_ENTER_GPIO16), IRQT_RISING); if (request_irq(OMAP_GPIO_IRQ(SW_ENTER_GPIO16), &apollon_sw_interrupt, - SA_SHIRQ, "enter sw", + IRQF_SHARED, "enter sw", &apollon_sw_interrupt)) return; set_irq_type(OMAP_GPIO_IRQ(SW_UP_GPIO17), IRQT_RISING); if (request_irq(OMAP_GPIO_IRQ(SW_UP_GPIO17), &apollon_sw_interrupt, - SA_SHIRQ, "up sw", + IRQF_SHARED, "up sw", &apollon_sw_interrupt)) return; set_irq_type(OMAP_GPIO_IRQ(SW_DOWN_GPIO58), IRQT_RISING); if (request_irq(OMAP_GPIO_IRQ(SW_DOWN_GPIO58), &apollon_sw_interrupt, - SA_SHIRQ, "down sw", + IRQF_SHARED, "down sw", &apollon_sw_interrupt)) return; } @@ -257,6 +257,9 @@ static void __init omap_apollon_init(void) /* REVISIT: where's the correct place */ omap_cfg_reg(W19_24XX_SYS_NIRQ); + /* Use Interal loop-back in MMC/SDIO Module Input Clock selection */ + CONTROL_DEVCONF |= (1 << 24); + /* * Make sure the serial ports are muxed on at this point. * You have to mux them off in device drivers later on |
