memory: add Atmel EBI (External Bus Interface) driver

The EBI (External Bus Interface) is used to access external peripherals
(NOR, SRAM, NAND, and other specific devices like ethernet controllers).
Each device is assigned a CS line and an address range and can have its
own configuration (timings, access mode, bus width, ...).
This driver provides a generic DT binding to configure a device according
to its requirements.
For specific device controllers (like the NAND one) the SMC timings
should be configured by the controller driver through the matrix and
smc syscon regmaps.

Signed-off-by: Boris Brezillon <boris.brezillon@free-electrons.com>
Signed-off-by: Alexandre Belloni <alexandre.belloni@free-electrons.com>

1 files changed, 11 insertions, 0 deletions

diff --git a/drivers/memory/Kconfig b/drivers/memory/Kconfig
index 81ddb17575a9..133712346911 100644
--- a/drivers/memory/Kconfig
+++ b/drivers/memory/Kconfig
@@ -25,6 +25,17 @@ config ATMEL_SDRAMC
 	  Starting with the at91sam9g45, this controller supports SDR, DDR and
 	  LP-DDR memories.
 
+config ATMEL_EBI
+	bool "Atmel EBI driver"
+	default y
+	depends on ARCH_AT91 && OF
+	select MFD_SYSCON
+	help
+	  Driver for Atmel EBI controller.
+	  Used to configure the EBI (external bus interface) when the device-
+	  tree is used. This bus supports NANDs, external ethernet controller,
+	  SRAMs, ATA devices, etc.
+
 config TI_AEMIF
 	tristate "Texas Instruments AEMIF driver"
 	depends on (ARCH_DAVINCI || ARCH_KEYSTONE) && OF