# Note : Assumes these vars were setup in startup.simics
# $hb_masterproc : name of master proc chip object
# $hb_pnor : name of pnor object associated with master proc

($hb_masterproc).proc_fsi2host_mbox->responder_enable=1

# Preload VPD in PNOR
foreach $pnor in (get-object-list Lpc2SpiFpgaCmp) {
    try {
        run-python-file (lookup-file hbfw/hb-pnor-vpd-preload.py)
            ($pnor).sfc_master_mem.load-file ./sysmvpd.dat.ecc 0x1C5000
            ($pnor).sfc_master_mem.load-file ./sysspd.dat.ecc 0x17D000
            ($pnor).sfc_master_mem.load-file ./syscvpd.dat.ecc 0x255000
    } except { echo "ERROR: Failed to preload VPD into PNOR." }
}

#Write the PNOR MMIO addr into Scratch 2, 0x283A
#($hb_masterproc).proc_lbus_map.write 0x28e8 0xFFF78000  #HB PNOR addr
foreach $cc in (get-object-list p8_proc) {
    ($cc).proc_lbus_map.write 0x28e8 0xFFF78000
}

# Loop through every processor chip
foreach $cc in (get-object-list p8_proc) {
    echo $cc

    #Trigger a power on to cec-chip
    echo "-Trigger power on"
    @mp="%s.proc_chip"%simenv.cc
    @SIM_get_interface(SIM_get_object(mp),"signal").signal_raise(SIM_get_object(mp))

    #Trigger the flush, load, and SBE start
    echo "-Trigger SBE"
    ($cc).proc_lbus_map.write 0x28E0 0x0000F3FF  #NonFunc EX (only 4,5 is good)
    ($cc).proc_lbus_map.write 0x2848 0x00000FFF  #GP3 0x2812 (flush)
    ($cc).proc_lbus_map.write 0x2870 0xB0000000  #SBE Vital 0x281C (load)
    ($cc).proc_lbus_map.write 0x2870 0x90000000  #SBE Vital 0x281C (start)
}

###################################
#Configure SFC (mimmic FSP Setup)
###################################
echo "Configure SFC"

foreach $pnor in (get-object-list Lpc2SpiFpgaCmp) {
    echo $pnor
    #Direct Read window config
    ($pnor).sfc_master->regs_OADRNB = 0xC000000
    ($pnor).sfc_master->regs_ADRCBF = 0x0
    ($pnor).sfc_master->regs_ADRCMF = 0xF

    #Direct Access Cache Disable
    ($pnor).sfc_master->regs_CONF = 0x00000002

    #Small Erase op code
    ($pnor).sfc_master->regs_CONF4 = 0x00000020
    #Erase Size
    ($pnor).sfc_master->regs_CONF5 = 0x1000

    #Enable 4 byte address mode - must write via memory to trigger
    #model behavior
    ($pnor).fsi_local_lbus_map.write 0xC40 0x00006E00
}