| Commit message (Collapse) | Author | Age | Files | Lines |
|---|
| |
|
|
|
|
|
|
|
|
|
| |
1) Get the interface mode of the system if it is not given
so that we can set the same interface mode as it was before.
2) Removed the unnecessary condition of getting the VLAN.
Resolves openbmc/openbmc#2738
Change-Id: I1658fbf78627e7cc1c7e1e5875964ed30c58d6dc
Signed-off-by: Ratan Gupta <ratagupt@in.ibm.com>
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
| |
Previously, the ipmi daemon only supported eth0 and hard-coded it
to channel 1. This allows one to map via a configuration. The
channel number provided is checked against a configuration to retrieve
the ethernet device identifier, e.g. eth0.
Tested: Ran on a quanta-q71l and was able to properly set MAC, IP,
Netmask, Gateway IP, and then verified the data was set for the eth1
via `ip addr show eth1`.
Change-Id: I92f63188297304e9454fd0d6fe32bc6cf84bb181
Signed-off-by: Patrick Venture <venture@google.com>
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
We did the filtering during IPAddress parameter
to avoid link local address but left it for subnetMask
and vlan parameter.
With the introduction of zeroconfig IP we have
multiIPaddress can exist on the interface.
This commit introduces the filtering for subnetmask and
vlan parameter also.
Resolves openbmc/openbmc#2664
Change-Id: I244bfe8b9d7efbf55fc1b7051489a8a204182906
Signed-off-by: Ratan Gupta <ratagupt@in.ibm.com>
|
|
|
I split out the channel commands into their own
subordinate file from the apphandler.cpp. There
are three commands in apphandler for the channel
information. There are other commands in the
transporthandler that correlate.
Moving this is step one in a larger task to enable
multiple channels.
Change-Id: I2e434a1da942325fc420079415edb39622f4e346
Signed-off-by: Patrick Venture <venture@google.com>
|
