From: Stephen Hemminger Date: Thu, 29 Oct 2009 06:37:09 +0000 (+0000) Subject: sky2: 88E8059 support X-Git-Tag: v2.6.33-rc1~388^2~588 X-Git-Url: http://git.kernel.org/?p=linux%2Fkernel%2Fgit%2Ftorvalds%2Flinux-2.6.git;a=commitdiff_plain;h=0f5aac7070a01ec757ed243febe4fff7c944c4d2 sky2: 88E8059 support Tentative support for newer Marvell hardware including the Yukon-2 Optima chip. Do not have hatdware to test this yet, code is based on vendor driver. Signed-off-by: Stephen Hemminger Signed-off-by: David S. Miller --- diff --git a/drivers/net/sky2.c b/drivers/net/sky2.c index 3387a2f..53cce74 100644 --- a/drivers/net/sky2.c +++ b/drivers/net/sky2.c @@ -140,6 +140,7 @@ static DEFINE_PCI_DEVICE_TABLE(sky2_id_table) = { { PCI_DEVICE(PCI_VENDOR_ID_MARVELL, 0x436D) }, /* 88E8055 */ { PCI_DEVICE(PCI_VENDOR_ID_MARVELL, 0x4370) }, /* 88E8075 */ { PCI_DEVICE(PCI_VENDOR_ID_MARVELL, 0x4380) }, /* 88E8057 */ + { PCI_DEVICE(PCI_VENDOR_ID_MARVELL, 0x4381) }, /* 88E8059 */ { 0 } }; @@ -603,6 +604,16 @@ static void sky2_phy_init(struct sky2_hw *hw, unsigned port) /* apply workaround for integrated resistors calibration */ gm_phy_write(hw, port, PHY_MARV_PAGE_ADDR, 17); gm_phy_write(hw, port, PHY_MARV_PAGE_DATA, 0x3f60); + } else if (hw->chip_id == CHIP_ID_YUKON_OPT && hw->chip_rev == 0) { + /* apply fixes in PHY AFE */ + gm_phy_write(hw, port, PHY_MARV_EXT_ADR, 0x00ff); + + /* apply RDAC termination workaround */ + gm_phy_write(hw, port, 24, 0x2800); + gm_phy_write(hw, port, 23, 0x2001); + + /* set page register back to 0 */ + gm_phy_write(hw, port, PHY_MARV_EXT_ADR, 0); } else if (hw->chip_id != CHIP_ID_YUKON_EX && hw->chip_id < CHIP_ID_YUKON_SUPR) { /* no effect on Yukon-XL */ @@ -2127,6 +2138,25 @@ out: spin_unlock(&sky2->phy_lock); } +/* Special quick link interrupt (Yukon-2 Optima only) */ +static void sky2_qlink_intr(struct sky2_hw *hw) +{ + struct sky2_port *sky2 = netdev_priv(hw->dev[0]); + u32 imask; + u16 phy; + + /* disable irq */ + imask = sky2_read32(hw, B0_IMSK); + imask &= ~Y2_IS_PHY_QLNK; + sky2_write32(hw, B0_IMSK, imask); + + /* reset PHY Link Detect */ + phy = sky2_pci_read16(hw, PSM_CONFIG_REG4); + sky2_pci_write16(hw, PSM_CONFIG_REG4, phy | 1); + + sky2_link_up(sky2); +} + /* Transmit timeout is only called if we are running, carrier is up * and tx queue is full (stopped). */ @@ -2796,6 +2826,9 @@ static int sky2_poll(struct napi_struct *napi, int work_limit) if (status & Y2_IS_IRQ_PHY2) sky2_phy_intr(hw, 1); + if (status & Y2_IS_PHY_QLNK) + sky2_qlink_intr(hw); + while ((idx = sky2_read16(hw, STAT_PUT_IDX)) != hw->st_idx) { work_done += sky2_status_intr(hw, work_limit - work_done, idx); @@ -2845,6 +2878,7 @@ static u32 sky2_mhz(const struct sky2_hw *hw) case CHIP_ID_YUKON_EX: case CHIP_ID_YUKON_SUPR: case CHIP_ID_YUKON_UL_2: + case CHIP_ID_YUKON_OPT: return 125; case CHIP_ID_YUKON_FE: @@ -2934,6 +2968,7 @@ static int __devinit sky2_init(struct sky2_hw *hw) break; case CHIP_ID_YUKON_UL_2: + case CHIP_ID_YUKON_OPT: hw->flags = SKY2_HW_GIGABIT | SKY2_HW_ADV_POWER_CTL; break; @@ -3024,6 +3059,46 @@ static void sky2_reset(struct sky2_hw *hw) sky2_pci_write32(hw, PCI_DEV_REG3, P_CLK_MACSEC_DIS); } + if (hw->chip_id == CHIP_ID_YUKON_OPT) { + u16 reg; + u32 msk; + + if (hw->chip_rev == 0) { + /* disable PCI-E PHY power down (set PHY reg 0x80, bit 7 */ + sky2_write32(hw, Y2_PEX_PHY_DATA, (0x80UL << 16) | (1 << 7)); + + /* set PHY Link Detect Timer to 1.1 second (11x 100ms) */ + reg = 10; + } else { + /* set PHY Link Detect Timer to 0.4 second (4x 100ms) */ + reg = 3; + } + + reg <<= PSM_CONFIG_REG4_TIMER_PHY_LINK_DETECT_BASE; + + /* reset PHY Link Detect */ + sky2_pci_write16(hw, PSM_CONFIG_REG4, + reg | PSM_CONFIG_REG4_RST_PHY_LINK_DETECT); + sky2_pci_write16(hw, PSM_CONFIG_REG4, reg); + + + /* enable PHY Quick Link */ + msk = sky2_read32(hw, B0_IMSK); + msk |= Y2_IS_PHY_QLNK; + sky2_write32(hw, B0_IMSK, msk); + + /* check if PSMv2 was running before */ + reg = sky2_pci_read16(hw, PSM_CONFIG_REG3); + if (reg & PCI_EXP_LNKCTL_ASPMC) { + int cap = pci_find_capability(pdev, PCI_CAP_ID_EXP); + /* restore the PCIe Link Control register */ + sky2_pci_write16(hw, cap + PCI_EXP_LNKCTL, reg); + } + + /* re-enable PEX PM in PEX PHY debug reg. 8 (clear bit 12) */ + sky2_write32(hw, Y2_PEX_PHY_DATA, PEX_DB_ACCESS | (0x08UL << 16)); + } + /* Clear I2C IRQ noise */ sky2_write32(hw, B2_I2C_IRQ, 1); @@ -4442,9 +4517,11 @@ static const char *sky2_name(u8 chipid, char *buf, int sz) "FE+", /* 0xb8 */ "Supreme", /* 0xb9 */ "UL 2", /* 0xba */ + "Unknown", /* 0xbb */ + "Optima", /* 0xbc */ }; - if (chipid >= CHIP_ID_YUKON_XL && chipid < CHIP_ID_YUKON_UL_2) + if (chipid >= CHIP_ID_YUKON_XL && chipid < CHIP_ID_YUKON_OPT) strncpy(buf, name[chipid - CHIP_ID_YUKON_XL], sz); else snprintf(buf, sz, "(chip %#x)", chipid);