/* Copyright 2013-2015 IBM Corp. * * Licensed under the Apache License, Version 2.0 (the "License"); * you may not use this file except in compliance with the License. * You may obtain a copy of the License at * * http://www.apache.org/licenses/LICENSE-2.0 * * Unless required by applicable law or agreed to in writing, software * distributed under the License is distributed on an "AS IS" BASIS, * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or * implied. * See the License for the specific language governing permissions and * limitations under the License. */ #include #include #include #include #include void nx_create_rng_node(struct dt_node *node) { u64 bar, cfg; u64 xbar, xcfg; u32 pb_base; u32 gcid; u64 rng_addr, rng_len, len, addr_mask; struct dt_node *rng; int rc; gcid = dt_get_chip_id(node); pb_base = dt_get_address(node, 0, NULL); if (dt_node_is_compatible(node, "ibm,power7-nx")) { xbar = pb_base + NX_P7_RNG_BAR; xcfg = pb_base + NX_P7_RNG_CFG; addr_mask = NX_P7_RNG_BAR_ADDR; } else if (dt_node_is_compatible(node, "ibm,power8-nx")) { xbar = pb_base + NX_P8_RNG_BAR; xcfg = pb_base + NX_P8_RNG_CFG; addr_mask = NX_P8_RNG_BAR_ADDR; } else { prerror("NX%d: Unknown NX type!\n", gcid); return; } rc = xscom_read(gcid, xbar, &bar); /* Get RNG BAR */ if (rc) return; /* Hope xscom always prints error message */ rc = xscom_read(gcid, xcfg, &cfg); /* Get RNG CFG */ if (rc) return; /* * We mask in-place rather than using GETFIELD for the base address * as we happen to *know* that it's properly aligned in the register. * * FIXME? Always assusme BAR gets a valid address from FSP */ rng_addr = bar & addr_mask; len = GETFIELD(NX_RNG_BAR_SIZE, bar); if (len > 4) { prerror("NX%d: Corrupted bar size %lld\n", gcid, len); return; } rng_len = (u64[]){ 0x1000, /* 4K */ 0x10000, /* 64K */ 0x400000000UL, /* 16G*/ 0x100000, /* 1M */ 0x1000000 /* 16M */} [len]; prlog(PR_INFO, "NX%d: RNG BAR set to 0x%016llx..0x%016llx\n", gcid, rng_addr, rng_addr + rng_len - 1); /* RNG must be enabled before MMIO is enabled */ rc = xscom_write(gcid, xcfg, cfg | NX_RNG_CFG_ENABLE); if (rc) return; /* The BAR needs to be enabled too */ rc = xscom_write(gcid, xbar, bar | NX_RNG_BAR_ENABLE); if (rc) return; rng = dt_new_addr(dt_root, "hwrng", rng_addr); if (!rng) return; dt_add_property_strings(rng, "compatible", "ibm,power-rng"); dt_add_property_u64s(rng, "reg", rng_addr, rng_len); dt_add_property_cells(rng, "ibm,chip-id", gcid); }