blob: a61979997f373c6e784865dbf5fe145fd388906e (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
|
* UPISEMI us5182d I2C ALS and Proximity sensor
Required properties:
- compatible: must be "upisemi,usd5182"
- reg: the I2C address of the device
Optional properties:
- upisemi,glass-coef: glass attenuation factor - compensation factor of
resolution 1000 for material transmittance.
- upisemi,dark-ths: array of 8 elements containing 16-bit thresholds (adc
counts) corresponding to every scale.
- upisemi,upper-dark-gain: 8-bit dark gain compensation factor(4 int and 4
fractional bits - Q4.4) applied when light > threshold
- upisemi,lower-dark-gain: 8-bit dark gain compensation factor(4 int and 4
fractional bits - Q4.4) applied when light < threshold
- upisemi,continuous: This chip has two power modes: one-shot (chip takes one
measurement and then shuts itself down) and continuous (
chip takes continuous measurements). The one-shot mode is
more power-friendly but the continuous mode may be more
reliable. If this property is specified the continuous
mode will be used instead of the default one-shot one for
raw reads.
If the optional properties are not specified these factors will default to the
values in the below example.
The glass-coef defaults to no compensation for the covering material.
The threshold array defaults to experimental values that work with US5182D
sensor on evaluation board - roughly between 12-32 lux.
There will be no dark-gain compensation by default when ALS > thresh
(0 * dark-gain), and a 1.35 compensation factor when ALS < thresh.
Example:
usd5182@39 {
compatible = "upisemi,usd5182";
reg = <0x39>;
upisemi,glass-coef = < 1000 >;
upisemi,dark-ths = /bits/ 16 <170 200 512 512 800 2000 4000 8000>;
upisemi,upper-dark-gain = /bits/ 8 <0x00>;
upisemi,lower-dark-gain = /bits/ 8 <0x16>;
};
|
