From ea505bc99f77f3f9db02bb965bd59ac5db063f60 Mon Sep 17 00:00:00 2001 From: Viresh Kumar Date: Thu, 19 Apr 2012 11:48:15 +0530 Subject: spi/pl022: Allow request for higher frequency than maximum possible Currently, if we request for frequency greater than maximum possible, spi driver returns error. For example, if the spi block src frequency is 333/4 MHz, i.e. 83.33.. MHz, maximum frequency programmable would be src/2. Which would come around 41.6... It is difficult to pass frequency in these figures. We normally try to program in round figures, like 42 MHz and it should get programmed to <= requested_frequency, i.e. 41.6... For this to happen, we must not return error even if requested freq is higher than max possible. But should program it to max possible. Reported-by: Vinit Kamalaksha Shenoy Signed-off-by: Viresh Kumar Acked-by: Linus Walleij Signed-off-by: Grant Likely --- drivers/spi/spi-pl022.c | 10 ++++++++-- 1 file changed, 8 insertions(+), 2 deletions(-) (limited to 'drivers/spi') diff --git a/drivers/spi/spi-pl022.c b/drivers/spi/spi-pl022.c index 8aa44e7adaef..400ae2121a2a 100644 --- a/drivers/spi/spi-pl022.c +++ b/drivers/spi/spi-pl022.c @@ -1667,9 +1667,15 @@ static int calculate_effective_freq(struct pl022 *pl022, int freq, struct /* cpsdvsr = 254 & scr = 255 */ min_tclk = spi_rate(rate, CPSDVR_MAX, SCR_MAX); - if (!((freq <= max_tclk) && (freq >= min_tclk))) { + if (freq > max_tclk) + dev_warn(&pl022->adev->dev, + "Max speed that can be programmed is %d Hz, you requested %d\n", + max_tclk, freq); + + if (freq < min_tclk) { dev_err(&pl022->adev->dev, - "controller data is incorrect: out of range frequency"); + "Requested frequency: %d Hz is less than minimum possible %d Hz\n", + freq, min_tclk); return -EINVAL; } -- cgit v1.2.1