From aeea64ac717a920ea655b061e37b14fbc872f7db Mon Sep 17 00:00:00 2001 From: Veaceslav Falico Date: Mon, 24 Jun 2013 11:49:32 +0200 Subject: bonding: don't trust arp requests unless active slave really works Currently, if we receive any arp packet on a backup slave in active-backup mode and arp_validate enabled, we suppose that it's an arp request, swap source/target ip and try to validate it. This optimization gives us virtually no downtime in the most common situation (active and backup slaves are in the same broadcast domain and the active slave failed). However, if we can't reach the arp_ip_target(s), we end up in an endless loop of reselecting slaves, because we receive our arp requests, sent by the active slave, and think that backup slaves are up, thus selecting them as active and, again, sending arp requests, which fool our backup slaves. Fix this by not validating the swapped arp packets if the current active slave didn't receive any arp reply after it was selected as active. This way we will only accept arp requests if we know that the current active slave can actually reach arp_ip_target. v3->v4: Obey 80 lines and make checkpatch.pl happy, per Sergei's suggestion. v1->v3: No change. Signed-off-by: Veaceslav Falico Signed-off-by: David S. Miller --- drivers/net/bonding/bond_main.c | 9 ++++++++- 1 file changed, 8 insertions(+), 1 deletion(-) (limited to 'drivers/net/bonding') diff --git a/drivers/net/bonding/bond_main.c b/drivers/net/bonding/bond_main.c index 7fe9802c9eec..d3a70c0d0edd 100644 --- a/drivers/net/bonding/bond_main.c +++ b/drivers/net/bonding/bond_main.c @@ -2677,10 +2677,17 @@ static int bond_arp_rcv(const struct sk_buff *skb, struct bonding *bond, * configuration, the ARP probe will (hopefully) travel from * the active, through one switch, the router, then the other * switch before reaching the backup. + * + * We 'trust' the arp requests if there is an active slave and + * it received valid arp reply(s) after it became active. This + * is done to avoid endless looping when we can't reach the + * arp_ip_target and fool ourselves with our own arp requests. */ if (bond_is_active_slave(slave)) bond_validate_arp(bond, slave, sip, tip); - else + else if (bond->curr_active_slave && + time_after(slave_last_rx(bond, bond->curr_active_slave), + bond->curr_active_slave->jiffies)) bond_validate_arp(bond, slave, tip, sip); out_unlock: -- cgit v1.2.1