summaryrefslogtreecommitdiffstats
path: root/arch/sh/kernel/asm-offsets.c
Commit message (Collapse)AuthorAgeFilesLines
* sh: Add R-standby sleep mode supportMagnus Damm2009-10-301-0/+3
| | | | | | | Add R-standby specific bits to the SuperH Mobile sleep code. Signed-off-by: Magnus Damm <damm@opensource.se> Signed-off-by: Paul Mundt <lethal@linux-sh.org>
* sh: Add MMU and Cache handling sleep mode codeMagnus Damm2009-10-301-0/+10
| | | | | | | | | | | | Add MMU and cache handling functionality to the SuperH Mobile sleep code. The MMU and cache registers are saved and restored. The MMU is disabled and the cache is flushed and disabled before entering sleep modes if the SUSP_SH_MMU flag is set. This flag should be set in the case of R-standby and most likely for future U-standby support as well. Signed-off-by: Magnus Damm <damm@opensource.se> Signed-off-by: Paul Mundt <lethal@linux-sh.org>
* sh: Rework SuperH Mobile sleep mode codeMagnus Damm2009-10-301-0/+10
| | | | | | | | | | Rework the SuperH Mobile sleep code from including board specific code to allowing each board to provide pre/post code snippets. These snippets should contain sdram management code to enter and leave self-refresh. Signed-off-by: Magnus Damm <damm@opensource.se> Signed-off-by: Paul Mundt <lethal@linux-sh.org>
* sh: Provide diagnostic kernel stack checksMatt Fleming2009-07-111-0/+1
| | | | | | | | | | Enable kernel stack checking code in both the dynamic ftrace and mcount code paths. Check the stack to see if it's overflowing and make sure that the stack pointer contains an address that's either in init_stack or after the bss. Signed-off-by: Matt Fleming <matt@console-pimps.org> Signed-off-by: Paul Mundt <lethal@linux-sh.org>
* sh: hibernation supportMagnus Damm2009-03-101-0/+8
| | | | | | | | | | | | | | | | | Add Suspend-to-disk / swsusp / CONFIG_HIBERNATION support to the SuperH architecture. To suspend, use "swapon /dev/sda2; echo disk > /sys/power/state" To resume, pass "resume=/dev/sda2" on the kernel command line. The patch "pm: rework includes, remove arch ifdefs V2" is needed to allow the generic swsusp code to build properly. Hibernation is not enabled with this patch though, a patch setting ARCH_HIBERNATION_POSSIBLE will be submitted later. Signed-off-by: Magnus Damm <damm@igel.co.jp> Signed-off-by: Paul Mundt <lethal@linux-sh.org>
* sh: use kbuild.h instead of defining macros in asm-offsets.cChristoph Lameter2008-04-291-5/+2
| | | | | | | Signed-off-by: Christoph Lameter <clameter@sgi.com> Cc: Paul Mundt <lethal@linux-sh.org> Signed-off-by: Andrew Morton <akpm@linux-foundation.org> Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
* Linux-2.6.12-rc2v2.6.12-rc2Linus Torvalds2005-04-161-0/+32
Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip!
OpenPOWER on IntegriCloud