summaryrefslogtreecommitdiffstats
path: root/arch/arm/boot/dts/omap3-gta04.dtsi
Commit message (Collapse)AuthorAgeFilesLines
* ARM: dts: omap3-gta04: remove unneeded unit namesJavier Martinez Canillas2016-06-291-4/+4
| | | | | | | | | | | | This patch fixes the following DTC warnings for omap3-gta04a3.dtb, omap3-gta04a4.dtb and omap3-gta04a5.dtb: "dmtimer-pwm@11 has a unit name, but no reg property" "connector@1 has a unit name, but no reg property" "endpoint@0 has a unit name, but no reg property" Signed-off-by: Javier Martinez Canillas <javier@osg.samsung.com> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dts: omap3-gta04: Add RFID eeprom nodeH. Nikolaus Schaller2016-06-101-0/+6
| | | | | | | | | Define RFID eeprom node which is present on gta04 device. Signed-off-by: H. Nikolaus Schaller <hns@goldelico.com> Signed-off-by: Marek Belisko <marek@goldelico.com> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dts: omap3-gat04: Fix wifi handlingH. Nikolaus Schaller2016-06-101-2/+8
| | | | | | | | Without that change wifi card isn't probed because pwrseq is necessary for libertas chip. Signed-off-by: H. Nikolaus Schaller <hns@goldelico.com> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dta: omap3-gta04: Define and use hmc5843 irq pinH. Nikolaus Schaller2016-06-101-0/+10
| | | | | | | Define pinmux and usage if irq pin. Signed-off-by: H. Nikolaus Schaller <hns@goldelico.com> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dta: omap3-gta04: Define and use itg3200 irq pinH. Nikolaus Schaller2016-06-101-1/+9
| | | | | | | Define pinmux and usage if irq pin + fix irq edge. Signed-off-by: H. Nikolaus Schaller <hns@goldelico.com> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dts: omap3-gta04: Define and use bma180 irq pinH. Nikolaus Schaller2016-06-101-0/+8
| | | | | | | Add pinmux and usage of bma180 irq pin. Signed-off-by: H. Nikolaus Schaller <hns@goldelico.com> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dts: omap3-gta04: Add backlight supportMarek Belisko2016-06-101-0/+22
| | | | | | | Define pwm backlight node which is using dmtimer pwm. Signed-off-by: Marek Belisko <marek@goldelico.com> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dts: omap3: Fix NAND device nodesRoger Quadros2016-02-261-0/+4
| | | | | | | | | | | Add compatible id, GPMC register resource and interrupt resource to NAND controller nodes. The GPMC node will provide an interrupt controller for the NAND IRQs. Signed-off-by: Roger Quadros <rogerq@ti.com> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dts: omap: replace legacy *,wakeup property with wakeup-sourceSudeep Holla2015-12-171-1/+1
| | | | | | | | | | | | | | | | Though the keyboard and other driver will continue to support the legacy "gpio-key,wakeup", "linux,wakeup" boolean property to enable the wakeup source, "wakeup-source" is the new standard binding. This patch replaces all the legacy wakeup properties with the unified "wakeup-source" property in order to avoid any futher copy-paste duplication. Cc: "Benoît Cousson" <bcousson@baylibre.com> Cc: Tony Lindgren <tony@atomide.com> Cc: linux-omap@vger.kernel.org Signed-off-by: Sudeep Holla <sudeep.holla@arm.com> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dts: Use defined GPIO constants in flags cell for OMAP2+ boardsJavier Martinez Canillas2015-10-121-5/+5
| | | | | | | | Many OMAP2+ DTS are not using the defined constants to express the GPIO polarity. Replace these so the DTS are easier to read. Signed-off-by: Javier Martinez Canillas <javier@osg.samsung.com> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dts: omap3-gta04: Add GSM audio supportMarek Belisko2015-05-201-0/+26
| | | | | | | | | | Add voice audio card which is used for telephony on gta04 board. gtm601 codec is UMTS modem with pcm interface which get samples from microphone and provide data from other party side. Use simple audio card to describe audio card. Signed-off-by: Marek Belisko <marek@goldelico.com> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dts: omap3-gta04: Add hdqw1 supportMarek Belisko2015-05-201-0/+11
| | | | | | | | Enable omap-hdq for battery fuel gauge access. Signed-off-by: Marek Belisko <marek@goldelico.com> Signed-off-by: H. Nikolaus Schaller <hns@goldelico.com> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dts: omap3: Remove all references to ti,codec propertyMarek Belisko2015-03-161-1/+0
| | | | | | | | | | ti,codec property is not used (parsed) in omap-twl4030 driver. The ti,twl4030-audio which ti,codec points by phandle is mfd driver and device for ASoC codec is created w/o DT compatible string. Removing all references in DT files. Signed-off-by: Marek Belisko <marek@goldelico.com> Acked-by: Peter Ujfalusi <peter.ujfalusi@ti.com> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dts: omap3-gta04: Disable keypadNeilBrown2015-01-261-0/+4
| | | | | | | | The twl4030 keypad is not wired up in the gta04, so mark it disabled to avoid pointless initialization. Signed-off-by: NeilBrown <neil@brown.name> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dts: omap3-gta04: only power DSS when necessary.NeilBrown2015-01-261-5/+1
| | | | | | | | i.e. configure vpll2 as a supply for the dss rather than being always-on. Signed-off-by: NeilBrown <neil@brown.name> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dts: omap3-gta04: add gyroscopeNeilBrown2015-01-261-0/+8
| | | | | Signed-off-by: NeilBrown <neil@brown.name> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dts: omap3-gta04: enable power-off for wifi card.NeilBrown2015-01-261-0/+1
| | | | | Signed-off-by: NeilBrown <neil@brown.name> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dts: omap3-gta04: add comments about gpiosNeilBrown2015-01-261-3/+3
| | | | | | | Add comments to state which GPIO is used for some interrupts. Signed-off-by: NeilBrown <neil@brown.name> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dts: omap3-gta04: Add ramp value for twl4030 audioMarek Belisko2015-01-261-0/+1
| | | | | Signed-off-by: Marek Belisko <marek@goldelico.com> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dts: omap3-gta04: Enable power-off using twl4030H. Nikolaus Schaller2015-01-261-0/+5
| | | | | | | Enabled poweroff through PMIC on GTA04. Signed-off-by: H. Nikolaus Schaller <hns@goldelico.com> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dts: omap3-gta04: Fix a GPIO line for bma180 nodeMarek Belisko2015-01-261-1/+1
| | | | | | | GPIO_115 used as irq is in &gpio4, not &gpio3. Signed-off-by: Marek Belisko <marek@goldelico.com> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dts: omap3-gta04: Enable twl audio vibra supportH. Nikolaus Schaller2015-01-261-0/+1
| | | | | Signed-off-by: H. Nikolaus Schaller <hns@goldelico.com> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dts: omap3-gta04: Enable mcbps2 necessary for audioH. Nikolaus Schaller2015-01-261-0/+4
| | | | | | | | mcbsp2 is used in gta04 soundcard config and by default is disabled so enable it for gta04. Signed-off-by: H. Nikolaus Schaller <hns@goldelico.com> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dts: omap3-gta04: Fix audio node malformattingH. Nikolaus Schaller2015-01-261-4/+4
| | | | | | | Audio should be child of twl node. Signed-off-by: H. Nikolaus Schaller <hns@goldelico.com> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dts: omap3-gta04: Fix backup-battery charging in devicetree file.H. Nikolaus Schaller2015-01-261-2/+2
| | | | | | | Fix attribute names. Signed-off-by: H. Nikolaus Schaller <hns@goldelico.com> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dts: omap3-gta04: Add handling for tv outputMarek Belisko2015-01-131-0/+49
| | | | | | | | | | | Add handling for gta04 tv out chain: venc -> opa362 -> svideo Use invert-polarity in venc node because opa362 is doing polarity inversion also. Signed-off-by: Marek Belisko <marek@goldelico.com> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dts: omap3-gta04: Use omap specific pinctrl definesMarek Belisko2014-11-101-41/+41
| | | | | | | | Use omap specific pinctrl defines (OMAP3_CORE1_IOPAD) to configure the padconf register offset. Signed-off-by: Marek Belisko <marek@goldelico.com> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dts: Fix wrong GPMC size mappings for omapsTony Lindgren2014-10-301-2/+2
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | The GPMC binding is obviously very confusing as the values are all over the place. People seem to confuse the GPMC partition size for the chip select, and the device IO size within the GPMC partition easily. The ranges entry contains the GPMC partition size. And the reg entry contains the size of the IO registers of the device connected to the GPMC. Let's fix the issue according to the following table: Device GPMC partition size Device IO size connected in the ranges entry in the reg entry NAND 0x01000000 (16MB) 4 16550 0x01000000 (16MB) 8 smc91x 0x01000000 (16MB) 0xf smc911x 0x01000000 (16MB) 0xff OneNAND 0x01000000 (16MB) 0x20000 (128KB) 16MB NOR 0x01000000 (16MB) 0x01000000 (16MB) 32MB NOR 0x02000000 (32MB) 0x02000000 (32MB) 64MB NOR 0x04000000 (64MB) 0x04000000 (64MB) 128MB NOR 0x08000000 (128MB) 0x08000000 (128MB) 256MB NOR 0x10000000 (256MB) 0x10000000 (256MB) Let's also add comments to the fixed entries while at it. Acked-by: Roger Quadros <rogerq@ti.com> Signed-off-by: Tony Lindgren <tony@atomide.com>
* ARM: dts: omap3-gta04: Rename gta04.dts to gta04.dtsi and add a4 modelMarek Belisko2014-07-291-0/+451
This patch is preparation of adding more boards which have common moved to omap3-gta04.dtsi. Other boards have only small additions to omap3-gta04a4. Signed-off-by: Marek Belisko <marek@goldelico.com> Signed-off-by: Tony Lindgren <tony@atomide.com>
OpenPOWER on IntegriCloud