summaryrefslogtreecommitdiffstats
Commit message (Expand)AuthorAgeFilesLines
...
| * [CIFS] redo existing session setup if needed in cifs_mountJeff Layton2007-12-312-2/+11
| * [CIFS] Only dump SPNEGO key if CONFIG_CIFS_DEBUG2 is setJeff Layton2007-12-311-2/+4
| * [CIFS] fix SetEA failure to some Samba versionsSteve French2007-12-302-2/+2
* | Merge git://git.kernel.org/pub/scm/linux/kernel/git/bart/ide-2.6Linus Torvalds2008-01-2665-1446/+999
|\ \
| * | ide: remove REQ_TYPE_ATA_CMDBartlomiej Zolnierkiewicz2008-01-263-113/+11
| * | ide: switch ide_cmd_ioctl() to use REQ_TYPE_ATA_TASKFILE requestsBartlomiej Zolnierkiewicz2008-01-262-34/+33
| * | ide: switch set_xfer_rate() to use REQ_TYPE_ATA_TASKFILE requestsBartlomiej Zolnierkiewicz2008-01-263-12/+11
| * | ide: fix final status check in drive_cmd_intr()Bartlomiej Zolnierkiewicz2008-01-261-2/+2
| * | ide: check BUSY and ERROR status bits before reading data in drive_cmd_intr()Bartlomiej Zolnierkiewicz2008-01-261-3/+8
| * | ide: don't enable local IRQs for PIO-in in driver_cmd_intr() (take 2)Bartlomiej Zolnierkiewicz2008-01-261-6/+9
| * | ide: convert "empty" REQ_TYPE_ATA_CMD requests to use REQ_TYPE_ATA_TASKFILEBartlomiej Zolnierkiewicz2008-01-263-3/+5
| * | ide: initialize rq->cmd_type in ide_init_drive_cmd() callersBartlomiej Zolnierkiewicz2008-01-263-1/+7
| * | ide: use wait_drive_not_busy() in drive_cmd_intr() (take 2)Bartlomiej Zolnierkiewicz2008-01-263-6/+5
| * | ide: kill DATA_READY defineBartlomiej Zolnierkiewicz2008-01-262-3/+2
| * | ide: task_end_request() fixTejun Heo2008-01-263-14/+7
| * | ide: use rq->nr_sectors in task_end_request()Bartlomiej Zolnierkiewicz2008-01-261-2/+2
| * | ide: remove needless ->cursg clearing from task_end_request()Bartlomiej Zolnierkiewicz2008-01-261-2/+0
| * | ide: set IDE_TFLAG_IN_* flags before queuing/executing commandBartlomiej Zolnierkiewicz2008-01-265-23/+26
| * | ide-tape: fix handling of non-special requests in ->end_request methodBartlomiej Zolnierkiewicz2008-01-261-0/+5
| * | ide: fix final status check in task_in_intr()Bartlomiej Zolnierkiewicz2008-01-261-1/+1
| * | ide: clear HOB bit for REQ_TYPE_ATA_CMD requests in ide_end_drive_cmd()Bartlomiej Zolnierkiewicz2008-01-261-0/+2
| * | ide: fix ->io_32bit race in ide_taskfile_ioctl()Tejun Heo2008-01-262-5/+14
| * | cmd64x: remove /proc/ide/cmd64xBartlomiej Zolnierkiewicz2008-01-261-113/+1
| * | ide: remove broken disk byte-swapping supportBartlomiej Zolnierkiewicz2008-01-265-41/+3
| * | ide: add ide_busy_sleep() helperBartlomiej Zolnierkiewicz2008-01-261-22/+21
| * | ide: make CONFIG_IDEPCI_PCIBUS_ORDER visible and deprecate itBartlomiej Zolnierkiewicz2008-01-261-1/+13
| * | ide: move CONFIG_IDEPCI_PCIBUS_ORDER code to ide-scan-pci.cBartlomiej Zolnierkiewicz2008-01-262-103/+110
| * | ide: print banner message once per controller in m68k host driversBartlomiej Zolnierkiewicz2008-01-265-35/+22
| * | ide: add ide_set_irq() inline helperBartlomiej Zolnierkiewicz2008-01-265-22/+17
| * | ide-pmac: use custom hwif->sg_max_nents only if DMA support is enabledBartlomiej Zolnierkiewicz2008-01-261-2/+2
| * | rapide: remove write-only hwif->hwif_dataBartlomiej Zolnierkiewicz2008-01-261-2/+0
| * | ide: use ide_init_port_hw() in setup-pci.cBartlomiej Zolnierkiewicz2008-01-261-16/+17
| * | ide: always use ide_std_init_ports() in setup-pci.cBartlomiej Zolnierkiewicz2008-01-261-5/+1
| * | au1xxx-ide: use ide_init_port_hw()Bartlomiej Zolnierkiewicz2008-01-261-4/+4
| * | au1xxx-ide: au_ide_probe() fixesBartlomiej Zolnierkiewicz2008-01-261-3/+2
| * | ide: make remaining built-in only IDE host drivers modular (take 2)Bartlomiej Zolnierkiewicz2008-01-2630-221/+171
| * | ide: fix host drivers depending on ide_generic to probe for interfaces (take 2)Bartlomiej Zolnierkiewicz2008-01-2613-16/+70
| * | cmd640: fix dependency on IDE_GENERICBartlomiej Zolnierkiewicz2008-01-261-0/+1
| * | ide: move ide_arm_init() call from init_ide_data() to ide_init()Bartlomiej Zolnierkiewicz2008-01-262-4/+3
| * | ide: drop 'initializing' argument from ide_register_hw()Bartlomiej Zolnierkiewicz2008-01-2615-67/+86
| * | ide: add ide_init_port_hw() helperBartlomiej Zolnierkiewicz2008-01-266-66/+81
| * | sgiioc4: always init hwif->io_portsBartlomiej Zolnierkiewicz2008-01-261-9/+6
| * | ide: Fix build break caused by "ide: remove ideprobe_init()"Olof Johansson2008-01-262-2/+2
| * | ide: remove ideprobe_init()Bartlomiej Zolnierkiewicz2008-01-263-41/+24
| * | ide: add hwif->chipset fixup to ide_device_add()Bartlomiej Zolnierkiewicz2008-01-261-1/+5
| * | swarm: set hwif->chipsetBartlomiej Zolnierkiewicz2008-01-261-0/+1
| * | rapide: set hwif->chipsetBartlomiej Zolnierkiewicz2008-01-261-0/+1
| * | ide: fix probing for hosts with serialized or IRQ sharing interfacesBartlomiej Zolnierkiewicz2008-01-261-2/+14
| * | ide: kill probe_hwif_init()Bartlomiej Zolnierkiewicz2008-01-261-21/+17
| * | ide: don't try to unregister interfaces if 'initializing' in ide_register_hw()Bartlomiej Zolnierkiewicz2008-01-261-2/+10
OpenPOWER on IntegriCloud