diff options
Diffstat (limited to 'include/net')
| -rw-r--r-- | include/net/mac80211.h | 19 |
1 files changed, 16 insertions, 3 deletions
diff --git a/include/net/mac80211.h b/include/net/mac80211.h index 183956e4930a..446dbf75a1c5 100644 --- a/include/net/mac80211.h +++ b/include/net/mac80211.h @@ -517,7 +517,7 @@ struct ieee80211_rx_status { * Flags to define PHY configuration options * * @IEEE80211_CONF_RADIOTAP: add radiotap header at receive time (if supported) - * @IEEE80211_CONF_PS: Enable 802.11 power save mode + * @IEEE80211_CONF_PS: Enable 802.11 power save mode (managed mode only) */ enum ieee80211_conf_flags { IEEE80211_CONF_RADIOTAP = (1<<0), @@ -553,14 +553,26 @@ enum ieee80211_conf_changed { * * This struct indicates how the driver shall configure the hardware. * + * @flags: configuration flags defined above + * * @radio_enabled: when zero, driver is required to switch off the radio. * @beacon_int: beacon interval (TODO make interface config) + * * @listen_interval: listen interval in units of beacon interval - * @flags: configuration flags defined above + * @max_sleep_interval: the maximum number of beacon intervals to sleep for + * before checking the beacon for a TIM bit (managed mode only); this + * value will be only achievable between DTIM frames, the hardware + * needs to check for the multicast traffic bit in DTIM beacons. + * This variable is valid only when the CONF_PS flag is set. + * @dynamic_ps_timeout: The dynamic powersave timeout (in ms), see the + * powersave documentation below. This variable is valid only when + * the CONF_PS flag is set. + * * @power_level: requested transmit power (in dBm) - * @dynamic_ps_timeout: dynamic powersave timeout (in ms) + * * @channel: the channel to tune to * @channel_type: the channel (HT) type + * * @long_frame_max_tx_count: Maximum number of transmissions for a "long" frame * (a frame not RTS protected), called "dot11LongRetryLimit" in 802.11, * but actually means the number of transmissions not the number of retries @@ -572,6 +584,7 @@ struct ieee80211_conf { int beacon_int; u32 flags; int power_level, dynamic_ps_timeout; + int max_sleep_interval; u16 listen_interval; bool radio_enabled; |
