diff options
Diffstat (limited to 'drivers/net/wireless/rt2x00/rt2800.h')
| -rw-r--r-- | drivers/net/wireless/rt2x00/rt2800.h | 93 |
1 files changed, 85 insertions, 8 deletions
diff --git a/drivers/net/wireless/rt2x00/rt2800.h b/drivers/net/wireless/rt2x00/rt2800.h index 2aa03751c341..ed4ebcdde7c9 100644 --- a/drivers/net/wireless/rt2x00/rt2800.h +++ b/drivers/net/wireless/rt2x00/rt2800.h @@ -63,7 +63,6 @@ */ #define REV_RT2860C 0x0100 #define REV_RT2860D 0x0101 -#define REV_RT2870D 0x0101 #define REV_RT2872E 0x0200 #define REV_RT3070E 0x0200 #define REV_RT3070F 0x0201 @@ -75,7 +74,7 @@ * Signal information. * Default offset is required for RSSI <-> dBm conversion. */ -#define DEFAULT_RSSI_OFFSET 120 /* FIXME */ +#define DEFAULT_RSSI_OFFSET 120 /* * Register layout information. @@ -99,6 +98,21 @@ */ /* + * E2PROM_CSR: PCI EEPROM control register. + * RELOAD: Write 1 to reload eeprom content. + * TYPE: 0: 93c46, 1:93c66. + * LOAD_STATUS: 1:loading, 0:done. + */ +#define E2PROM_CSR 0x0004 +#define E2PROM_CSR_DATA_CLOCK FIELD32(0x00000001) +#define E2PROM_CSR_CHIP_SELECT FIELD32(0x00000002) +#define E2PROM_CSR_DATA_IN FIELD32(0x00000004) +#define E2PROM_CSR_DATA_OUT FIELD32(0x00000008) +#define E2PROM_CSR_TYPE FIELD32(0x00000030) +#define E2PROM_CSR_LOAD_STATUS FIELD32(0x00000040) +#define E2PROM_CSR_RELOAD FIELD32(0x00000080) + +/* * OPT_14: Unknown register used by rt3xxx devices. */ #define OPT_14_CSR 0x0114 @@ -322,6 +336,39 @@ #define RX_DRX_IDX 0x029c /* + * USB_DMA_CFG + * RX_BULK_AGG_TIMEOUT: Rx Bulk Aggregation TimeOut in unit of 33ns. + * RX_BULK_AGG_LIMIT: Rx Bulk Aggregation Limit in unit of 256 bytes. + * PHY_CLEAR: phy watch dog enable. + * TX_CLEAR: Clear USB DMA TX path. + * TXOP_HALT: Halt TXOP count down when TX buffer is full. + * RX_BULK_AGG_EN: Enable Rx Bulk Aggregation. + * RX_BULK_EN: Enable USB DMA Rx. + * TX_BULK_EN: Enable USB DMA Tx. + * EP_OUT_VALID: OUT endpoint data valid. + * RX_BUSY: USB DMA RX FSM busy. + * TX_BUSY: USB DMA TX FSM busy. + */ +#define USB_DMA_CFG 0x02a0 +#define USB_DMA_CFG_RX_BULK_AGG_TIMEOUT FIELD32(0x000000ff) +#define USB_DMA_CFG_RX_BULK_AGG_LIMIT FIELD32(0x0000ff00) +#define USB_DMA_CFG_PHY_CLEAR FIELD32(0x00010000) +#define USB_DMA_CFG_TX_CLEAR FIELD32(0x00080000) +#define USB_DMA_CFG_TXOP_HALT FIELD32(0x00100000) +#define USB_DMA_CFG_RX_BULK_AGG_EN FIELD32(0x00200000) +#define USB_DMA_CFG_RX_BULK_EN FIELD32(0x00400000) +#define USB_DMA_CFG_TX_BULK_EN FIELD32(0x00800000) +#define USB_DMA_CFG_EP_OUT_VALID FIELD32(0x3f000000) +#define USB_DMA_CFG_RX_BUSY FIELD32(0x40000000) +#define USB_DMA_CFG_TX_BUSY FIELD32(0x80000000) + +/* + * US_CYC_CNT + */ +#define US_CYC_CNT 0x02a4 +#define US_CYC_CNT_CLOCK_CYCLE FIELD32(0x000000ff) + +/* * PBF_SYS_CTRL * HOST_RAM_WRITE: enable Host program ram write selection */ @@ -672,14 +719,20 @@ #define TBTT_TIMER 0x1124 /* - * INT_TIMER_CFG: + * INT_TIMER_CFG: timer configuration + * PRE_TBTT_TIMER: leadtime to tbtt for pretbtt interrupt in units of 1/16 TU + * GP_TIMER: period of general purpose timer in units of 1/16 TU */ #define INT_TIMER_CFG 0x1128 +#define INT_TIMER_CFG_PRE_TBTT_TIMER FIELD32(0x0000ffff) +#define INT_TIMER_CFG_GP_TIMER FIELD32(0xffff0000) /* * INT_TIMER_EN: GP-timer and pre-tbtt Int enable */ #define INT_TIMER_EN 0x112c +#define INT_TIMER_EN_PRE_TBTT_TIMER FIELD32(0x00000001) +#define INT_TIMER_EN_GP_TIMER FIELD32(0x00000002) /* * CH_IDLE_STA: channel idle time @@ -756,6 +809,18 @@ #define EDCA_TID_AC_MAP 0x1310 /* + * TX_PWR_CFG: + */ +#define TX_PWR_CFG_RATE0 FIELD32(0x0000000f) +#define TX_PWR_CFG_RATE1 FIELD32(0x000000f0) +#define TX_PWR_CFG_RATE2 FIELD32(0x00000f00) +#define TX_PWR_CFG_RATE3 FIELD32(0x0000f000) +#define TX_PWR_CFG_RATE4 FIELD32(0x000f0000) +#define TX_PWR_CFG_RATE5 FIELD32(0x00f00000) +#define TX_PWR_CFG_RATE6 FIELD32(0x0f000000) +#define TX_PWR_CFG_RATE7 FIELD32(0xf0000000) + +/* * TX_PWR_CFG_0: */ #define TX_PWR_CFG_0 0x1314 @@ -1370,17 +1435,17 @@ struct mac_wcid_entry { u8 mac[6]; u8 reserved[2]; -} __attribute__ ((packed)); +} __packed; struct hw_key_entry { u8 key[16]; u8 tx_mic[8]; u8 rx_mic[8]; -} __attribute__ ((packed)); +} __packed; struct mac_iveiv_entry { u8 iv[8]; -} __attribute__ ((packed)); +} __packed; /* * MAC_WCID_ATTRIBUTE: @@ -1389,6 +1454,10 @@ struct mac_iveiv_entry { #define MAC_WCID_ATTRIBUTE_CIPHER FIELD32(0x0000000e) #define MAC_WCID_ATTRIBUTE_BSS_IDX FIELD32(0x00000070) #define MAC_WCID_ATTRIBUTE_RX_WIUDF FIELD32(0x00000380) +#define MAC_WCID_ATTRIBUTE_CIPHER_EXT FIELD32(0x00000400) +#define MAC_WCID_ATTRIBUTE_BSS_IDX_EXT FIELD32(0x00000800) +#define MAC_WCID_ATTRIBUTE_WAPI_MCBC FIELD32(0x00008000) +#define MAC_WCID_ATTRIBUTE_WAPI_KEY_IDX FIELD32(0xff000000) /* * SHARED_KEY_MODE: @@ -1510,7 +1579,9 @@ struct mac_iveiv_entry { */ /* - * BBP 1: TX Antenna + * BBP 1: TX Antenna & Power + * POWER: 0 - normal, 1 - drop tx power by 6dBm, 2 - drop tx power by 12dBm, + * 3 - increase tx power by 6dBm */ #define BBP1_TX_POWER FIELD8(0x07) #define BBP1_TX_ANTENNA FIELD8(0x18) @@ -1800,9 +1871,15 @@ struct mac_iveiv_entry { #define EEPROM_TXPOWER_A_2 FIELD16(0xff00) /* - * EEPROM TXpower byrate: 20MHZ power + * EEPROM TXPOWER by rate: tx power per tx rate for HT20 mode */ #define EEPROM_TXPOWER_BYRATE 0x006f +#define EEPROM_TXPOWER_BYRATE_SIZE 9 + +#define EEPROM_TXPOWER_BYRATE_RATE0 FIELD16(0x000f) +#define EEPROM_TXPOWER_BYRATE_RATE1 FIELD16(0x00f0) +#define EEPROM_TXPOWER_BYRATE_RATE2 FIELD16(0x0f00) +#define EEPROM_TXPOWER_BYRATE_RATE3 FIELD16(0xf000) /* * EEPROM BBP. |
