diff options
Diffstat (limited to 'drivers/net/ucc_geth.c')
| -rw-r--r-- | drivers/net/ucc_geth.c | 58 |
1 files changed, 57 insertions, 1 deletions
diff --git a/drivers/net/ucc_geth.c b/drivers/net/ucc_geth.c index 0cf22c4f123b..255d28d4f84e 100644 --- a/drivers/net/ucc_geth.c +++ b/drivers/net/ucc_geth.c @@ -1,5 +1,5 @@ /* - * Copyright (C) 2006-2007 Freescale Semicondutor, Inc. All rights reserved. + * Copyright (C) 2006-2009 Freescale Semicondutor, Inc. All rights reserved. * * Author: Shlomi Gridish <gridish@freescale.com> * Li Yang <leoli@freescale.com> @@ -1410,6 +1410,9 @@ static int adjust_enet_interface(struct ucc_geth_private *ugeth) (ugeth->phy_interface == PHY_INTERFACE_MODE_RTBI)) { upsmr |= UCC_GETH_UPSMR_TBIM; } + if ((ugeth->phy_interface == PHY_INTERFACE_MODE_SGMII)) + upsmr |= UCC_GETH_UPSMR_SGMM; + out_be32(&uf_regs->upsmr, upsmr); /* Disable autonegotiation in tbi mode, because by default it @@ -1531,6 +1534,49 @@ static void adjust_link(struct net_device *dev) spin_unlock_irqrestore(&ugeth->lock, flags); } +/* Initialize TBI PHY interface for communicating with the + * SERDES lynx PHY on the chip. We communicate with this PHY + * through the MDIO bus on each controller, treating it as a + * "normal" PHY at the address found in the UTBIPA register. We assume + * that the UTBIPA register is valid. Either the MDIO bus code will set + * it to a value that doesn't conflict with other PHYs on the bus, or the + * value doesn't matter, as there are no other PHYs on the bus. + */ +static void uec_configure_serdes(struct net_device *dev) +{ + struct ucc_geth_private *ugeth = netdev_priv(dev); + struct ucc_geth_info *ug_info = ugeth->ug_info; + struct phy_device *tbiphy; + + if (!ug_info->tbi_node) { + dev_warn(&dev->dev, "SGMII mode requires that the device " + "tree specify a tbi-handle\n"); + return; + } + + tbiphy = of_phy_find_device(ug_info->tbi_node); + if (!tbiphy) { + dev_err(&dev->dev, "error: Could not get TBI device\n"); + return; + } + + /* + * If the link is already up, we must already be ok, and don't need to + * configure and reset the TBI<->SerDes link. Maybe U-Boot configured + * everything for us? Resetting it takes the link down and requires + * several seconds for it to come back. + */ + if (phy_read(tbiphy, ENET_TBI_MII_SR) & TBISR_LSTATUS) + return; + + /* Single clk mode, mii mode off(for serdes communication) */ + phy_write(tbiphy, ENET_TBI_MII_ANA, TBIANA_SETTINGS); + + phy_write(tbiphy, ENET_TBI_MII_TBICON, TBICON_CLK_SELECT); + + phy_write(tbiphy, ENET_TBI_MII_CR, TBICR_SETTINGS); +} + /* Configure the PHY for dev. * returns 0 if success. -1 if failure */ @@ -1554,6 +1600,9 @@ static int init_phy(struct net_device *dev) return -ENODEV; } + if (priv->phy_interface == PHY_INTERFACE_MODE_SGMII) + uec_configure_serdes(dev); + phydev->supported &= (ADVERTISED_10baseT_Half | ADVERTISED_10baseT_Full | ADVERTISED_100baseT_Half | @@ -3523,6 +3572,8 @@ static phy_interface_t to_phy_interface(const char *phy_connection_type) return PHY_INTERFACE_MODE_RGMII_RXID; if (strcasecmp(phy_connection_type, "rtbi") == 0) return PHY_INTERFACE_MODE_RTBI; + if (strcasecmp(phy_connection_type, "sgmii") == 0) + return PHY_INTERFACE_MODE_SGMII; return PHY_INTERFACE_MODE_MII; } @@ -3567,6 +3618,7 @@ static int ucc_geth_probe(struct of_device* ofdev, const struct of_device_id *ma PHY_INTERFACE_MODE_RMII, PHY_INTERFACE_MODE_RGMII, PHY_INTERFACE_MODE_GMII, PHY_INTERFACE_MODE_RGMII, PHY_INTERFACE_MODE_TBI, PHY_INTERFACE_MODE_RTBI, + PHY_INTERFACE_MODE_SGMII, }; ugeth_vdbg("%s: IN", __func__); @@ -3658,6 +3710,9 @@ static int ucc_geth_probe(struct of_device* ofdev, const struct of_device_id *ma } ug_info->phy_node = phy; + /* Find the TBI PHY node. If it's not there, we don't support SGMII */ + ug_info->tbi_node = of_parse_phandle(np, "tbi-handle", 0); + /* get the phy interface type, or default to MII */ prop = of_get_property(np, "phy-connection-type", NULL); if (!prop) { @@ -3682,6 +3737,7 @@ static int ucc_geth_probe(struct of_device* ofdev, const struct of_device_id *ma case PHY_INTERFACE_MODE_RGMII_TXID: case PHY_INTERFACE_MODE_TBI: case PHY_INTERFACE_MODE_RTBI: + case PHY_INTERFACE_MODE_SGMII: max_speed = SPEED_1000; break; default: |
