diff options
Diffstat (limited to 'drivers/net/ethernet/sfc/spi.h')
| -rw-r--r-- | drivers/net/ethernet/sfc/spi.h | 99 |
1 files changed, 99 insertions, 0 deletions
diff --git a/drivers/net/ethernet/sfc/spi.h b/drivers/net/ethernet/sfc/spi.h new file mode 100644 index 000000000000..71f2e3ebe1c7 --- /dev/null +++ b/drivers/net/ethernet/sfc/spi.h @@ -0,0 +1,99 @@ +/**************************************************************************** + * Driver for Solarflare Solarstorm network controllers and boards + * Copyright 2005 Fen Systems Ltd. + * Copyright 2006-2010 Solarflare Communications Inc. + * + * This program is free software; you can redistribute it and/or modify it + * under the terms of the GNU General Public License version 2 as published + * by the Free Software Foundation, incorporated herein by reference. + */ + +#ifndef EFX_SPI_H +#define EFX_SPI_H + +#include "net_driver.h" + +/************************************************************************** + * + * Basic SPI command set and bit definitions + * + *************************************************************************/ + +#define SPI_WRSR 0x01 /* Write status register */ +#define SPI_WRITE 0x02 /* Write data to memory array */ +#define SPI_READ 0x03 /* Read data from memory array */ +#define SPI_WRDI 0x04 /* Reset write enable latch */ +#define SPI_RDSR 0x05 /* Read status register */ +#define SPI_WREN 0x06 /* Set write enable latch */ +#define SPI_SST_EWSR 0x50 /* SST: Enable write to status register */ + +#define SPI_STATUS_WPEN 0x80 /* Write-protect pin enabled */ +#define SPI_STATUS_BP2 0x10 /* Block protection bit 2 */ +#define SPI_STATUS_BP1 0x08 /* Block protection bit 1 */ +#define SPI_STATUS_BP0 0x04 /* Block protection bit 0 */ +#define SPI_STATUS_WEN 0x02 /* State of the write enable latch */ +#define SPI_STATUS_NRDY 0x01 /* Device busy flag */ + +/** + * struct efx_spi_device - an Efx SPI (Serial Peripheral Interface) device + * @device_id: Controller's id for the device + * @size: Size (in bytes) + * @addr_len: Number of address bytes in read/write commands + * @munge_address: Flag whether addresses should be munged. + * Some devices with 9-bit addresses (e.g. AT25040A EEPROM) + * use bit 3 of the command byte as address bit A8, rather + * than having a two-byte address. If this flag is set, then + * commands should be munged in this way. + * @erase_command: Erase command (or 0 if sector erase not needed). + * @erase_size: Erase sector size (in bytes) + * Erase commands affect sectors with this size and alignment. + * This must be a power of two. + * @block_size: Write block size (in bytes). + * Write commands are limited to blocks with this size and alignment. + */ +struct efx_spi_device { + int device_id; + unsigned int size; + unsigned int addr_len; + unsigned int munge_address:1; + u8 erase_command; + unsigned int erase_size; + unsigned int block_size; +}; + +static inline bool efx_spi_present(const struct efx_spi_device *spi) +{ + return spi->size != 0; +} + +int falcon_spi_cmd(struct efx_nic *efx, + const struct efx_spi_device *spi, unsigned int command, + int address, const void* in, void *out, size_t len); +int falcon_spi_wait_write(struct efx_nic *efx, + const struct efx_spi_device *spi); +int falcon_spi_read(struct efx_nic *efx, + const struct efx_spi_device *spi, loff_t start, + size_t len, size_t *retlen, u8 *buffer); +int falcon_spi_write(struct efx_nic *efx, + const struct efx_spi_device *spi, loff_t start, + size_t len, size_t *retlen, const u8 *buffer); + +/* + * SFC4000 flash is partitioned into: + * 0-0x400 chip and board config (see falcon_hwdefs.h) + * 0x400-0x8000 unused (or may contain VPD if EEPROM not present) + * 0x8000-end boot code (mapped to PCI expansion ROM) + * SFC4000 small EEPROM (size < 0x400) is used for VPD only. + * SFC4000 large EEPROM (size >= 0x400) is partitioned into: + * 0-0x400 chip and board config + * configurable VPD + * 0x800-0x1800 boot config + * Aside from the chip and board config, all of these are optional and may + * be absent or truncated depending on the devices used. + */ +#define FALCON_NVCONFIG_END 0x400U +#define FALCON_FLASH_BOOTCODE_START 0x8000U +#define EFX_EEPROM_BOOTCONFIG_START 0x800U +#define EFX_EEPROM_BOOTCONFIG_END 0x1800U + +#endif /* EFX_SPI_H */ |
