1 files changed, 22 insertions, 6 deletions

diff --git a/drivers/net/ethernet/marvell/sky2.c b/drivers/net/ethernet/marvell/sky2.c
index cace36f2ab92..2b0748dba8b8 100644
--- a/drivers/net/ethernet/marvell/sky2.c
+++ b/drivers/net/ethernet/marvell/sky2.c
@@ -141,6 +141,7 @@ static DEFINE_PCI_DEVICE_TABLE(sky2_id_table) = {
 	{ PCI_DEVICE(PCI_VENDOR_ID_MARVELL, 0x4370) }, /* 88E8075 */
 	{ PCI_DEVICE(PCI_VENDOR_ID_MARVELL, 0x4380) }, /* 88E8057 */
 	{ PCI_DEVICE(PCI_VENDOR_ID_MARVELL, 0x4381) }, /* 88E8059 */
+	{ PCI_DEVICE(PCI_VENDOR_ID_MARVELL, 0x4382) }, /* 88E8079 */
 	{ 0 }
 };
 
@@ -3079,8 +3080,10 @@ static irqreturn_t sky2_intr(int irq, void *dev_id)
 
 	/* Reading this mask interrupts as side effect */
 	status = sky2_read32(hw, B0_Y2_SP_ISRC2);
-	if (status == 0 || status == ~0)
+	if (status == 0 || status == ~0) {
+		sky2_write32(hw, B0_Y2_SP_ICR, 2);
 		return IRQ_NONE;
+	}
 
 	prefetch(&hw->st_le[hw->st_idx]);
 
@@ -3349,6 +3352,17 @@ static void sky2_reset(struct sky2_hw *hw)
 			sky2_pci_write16(hw, pdev->pcie_cap + PCI_EXP_LNKCTL,
 					 reg);
 
+		if (hw->chip_id == CHIP_ID_YUKON_PRM &&
+			hw->chip_rev == CHIP_REV_YU_PRM_A0) {
+			/* change PHY Interrupt polarity to low active */
+			reg = sky2_read16(hw, GPHY_CTRL);
+			sky2_write16(hw, GPHY_CTRL, reg | GPC_INTPOL);
+
+			/* adapt HW for low active PHY Interrupt */
+			reg = sky2_read16(hw, Y2_CFG_SPC + PCI_LDO_CTRL);
+			sky2_write16(hw, Y2_CFG_SPC + PCI_LDO_CTRL, reg | PHY_M_UNDOC1);
+		}
+
 		sky2_write8(hw, B2_TST_CTRL1, TST_CFG_WRITE_OFF);
 
 		/* re-enable PEX PM in PEX PHY debug reg. 8 (clear bit 12) */
@@ -4381,10 +4395,12 @@ static int sky2_set_features(struct net_device *dev, netdev_features_t features)
 	struct sky2_port *sky2 = netdev_priv(dev);
 	netdev_features_t changed = dev->features ^ features;
 
-	if (changed & NETIF_F_RXCSUM) {
-		bool on = features & NETIF_F_RXCSUM;
-		sky2_write32(sky2->hw, Q_ADDR(rxqaddr[sky2->port], Q_CSR),
-			     on ? BMU_ENA_RX_CHKSUM : BMU_DIS_RX_CHKSUM);
+	if ((changed & NETIF_F_RXCSUM) &&
+	    !(sky2->hw->flags & SKY2_HW_NEW_LE)) {
+		sky2_write32(sky2->hw,
+			     Q_ADDR(rxqaddr[sky2->port], Q_CSR),
+			     (features & NETIF_F_RXCSUM)
+			     ? BMU_ENA_RX_CHKSUM : BMU_DIS_RX_CHKSUM);
 	}
 
 	if (changed & NETIF_F_RXHASH)
@@ -4869,7 +4885,7 @@ static const char *sky2_name(u8 chipid, char *buf, int sz)
 		"UL 2",		/* 0xba */
 		"Unknown",	/* 0xbb */
 		"Optima",	/* 0xbc */
-		"Optima Prime", /* 0xbd */
+		"OptimaEEE",    /* 0xbd */
 		"Optima 2",	/* 0xbe */
 	};