diff options
Diffstat (limited to 'drivers/gpu/drm/i915')
| -rw-r--r-- | drivers/gpu/drm/i915/i915_drv.h | 2 | ||||
| -rw-r--r-- | drivers/gpu/drm/i915/intel_crt.c | 20 | ||||
| -rw-r--r-- | drivers/gpu/drm/i915/intel_dp.c | 2 | ||||
| -rw-r--r-- | drivers/gpu/drm/i915/intel_drv.h | 2 | ||||
| -rw-r--r-- | drivers/gpu/drm/i915/intel_i2c.c | 25 | ||||
| -rw-r--r-- | drivers/gpu/drm/i915/intel_lvds.c | 34 | ||||
| -rw-r--r-- | drivers/gpu/drm/i915/intel_sdvo_regs.h | 2 |
7 files changed, 27 insertions, 60 deletions
diff --git a/drivers/gpu/drm/i915/i915_drv.h b/drivers/gpu/drm/i915/i915_drv.h index 5004724ea57e..1c1b27c97e5c 100644 --- a/drivers/gpu/drm/i915/i915_drv.h +++ b/drivers/gpu/drm/i915/i915_drv.h @@ -630,7 +630,7 @@ typedef struct drm_i915_private { * Flag if the hardware appears to be wedged. * * This is set when attempts to idle the device timeout. - * It prevents command submission from occuring and makes + * It prevents command submission from occurring and makes * every pending request fail */ atomic_t wedged; diff --git a/drivers/gpu/drm/i915/intel_crt.c b/drivers/gpu/drm/i915/intel_crt.c index 8342259f3160..d03fc05b39c0 100644 --- a/drivers/gpu/drm/i915/intel_crt.c +++ b/drivers/gpu/drm/i915/intel_crt.c @@ -269,21 +269,6 @@ static bool intel_crt_detect_hotplug(struct drm_connector *connector) return ret; } -static bool intel_crt_ddc_probe(struct drm_i915_private *dev_priv, int ddc_bus) -{ - u8 buf; - struct i2c_msg msgs[] = { - { - .addr = 0xA0, - .flags = 0, - .len = 1, - .buf = &buf, - }, - }; - /* DDC monitor detect: Does it ACK a write to 0xA0? */ - return i2c_transfer(&dev_priv->gmbus[ddc_bus].adapter, msgs, 1) == 1; -} - static bool intel_crt_detect_ddc(struct drm_connector *connector) { struct intel_crt *crt = intel_attached_crt(connector); @@ -293,11 +278,6 @@ static bool intel_crt_detect_ddc(struct drm_connector *connector) if (crt->base.type != INTEL_OUTPUT_ANALOG) return false; - if (intel_crt_ddc_probe(dev_priv, dev_priv->crt_ddc_pin)) { - DRM_DEBUG_KMS("CRT detected via DDC:0xa0\n"); - return true; - } - if (intel_ddc_probe(&crt->base, dev_priv->crt_ddc_pin)) { struct edid *edid; bool is_digital = false; diff --git a/drivers/gpu/drm/i915/intel_dp.c b/drivers/gpu/drm/i915/intel_dp.c index 0daefca5cbb8..cb8578b7e443 100644 --- a/drivers/gpu/drm/i915/intel_dp.c +++ b/drivers/gpu/drm/i915/intel_dp.c @@ -213,7 +213,7 @@ intel_dp_mode_valid(struct drm_connector *connector, return MODE_PANEL; } - /* only refuse the mode on non eDP since we have seen some wierd eDP panels + /* only refuse the mode on non eDP since we have seen some weird eDP panels which are outside spec tolerances but somehow work by magic */ if (!is_edp(intel_dp) && (intel_dp_link_required(connector->dev, intel_dp, mode->clock) diff --git a/drivers/gpu/drm/i915/intel_drv.h b/drivers/gpu/drm/i915/intel_drv.h index 5daa991cb287..f5b0d8306d83 100644 --- a/drivers/gpu/drm/i915/intel_drv.h +++ b/drivers/gpu/drm/i915/intel_drv.h @@ -39,7 +39,7 @@ ret__ = -ETIMEDOUT; \ break; \ } \ - if (W && !in_dbg_master()) msleep(W); \ + if (W && !(in_atomic() || in_dbg_master())) msleep(W); \ } \ ret__; \ }) diff --git a/drivers/gpu/drm/i915/intel_i2c.c b/drivers/gpu/drm/i915/intel_i2c.c index 82d04c5899d2..d3b903bce7c5 100644 --- a/drivers/gpu/drm/i915/intel_i2c.c +++ b/drivers/gpu/drm/i915/intel_i2c.c @@ -259,7 +259,7 @@ gmbus_xfer(struct i2c_adapter *adapter, if (wait_for(I915_READ(GMBUS2 + reg_offset) & (GMBUS_SATOER | GMBUS_HW_RDY), 50)) goto timeout; if (I915_READ(GMBUS2 + reg_offset) & GMBUS_SATOER) - return 0; + goto clear_err; val = I915_READ(GMBUS3 + reg_offset); do { @@ -287,7 +287,7 @@ gmbus_xfer(struct i2c_adapter *adapter, if (wait_for(I915_READ(GMBUS2 + reg_offset) & (GMBUS_SATOER | GMBUS_HW_RDY), 50)) goto timeout; if (I915_READ(GMBUS2 + reg_offset) & GMBUS_SATOER) - return 0; + goto clear_err; val = loop = 0; do { @@ -302,14 +302,31 @@ gmbus_xfer(struct i2c_adapter *adapter, if (i + 1 < num && wait_for(I915_READ(GMBUS2 + reg_offset) & (GMBUS_SATOER | GMBUS_HW_WAIT_PHASE), 50)) goto timeout; if (I915_READ(GMBUS2 + reg_offset) & GMBUS_SATOER) - return 0; + goto clear_err; } - return num; + goto done; + +clear_err: + /* Toggle the Software Clear Interrupt bit. This has the effect + * of resetting the GMBUS controller and so clearing the + * BUS_ERROR raised by the slave's NAK. + */ + I915_WRITE(GMBUS1 + reg_offset, GMBUS_SW_CLR_INT); + I915_WRITE(GMBUS1 + reg_offset, 0); + +done: + /* Mark the GMBUS interface as disabled. We will re-enable it at the + * start of the next xfer, till then let it sleep. + */ + I915_WRITE(GMBUS0 + reg_offset, 0); + return i; timeout: DRM_INFO("GMBUS timed out, falling back to bit banging on pin %d [%s]\n", bus->reg0 & 0xff, bus->adapter.name); + I915_WRITE(GMBUS0 + reg_offset, 0); + /* Hardware may not support GMBUS over these pins? Try GPIO bitbanging instead. */ bus->force_bit = intel_gpio_create(dev_priv, bus->reg0 & 0xff); if (!bus->force_bit) diff --git a/drivers/gpu/drm/i915/intel_lvds.c b/drivers/gpu/drm/i915/intel_lvds.c index 1a311ad01116..a562bd2648c7 100644 --- a/drivers/gpu/drm/i915/intel_lvds.c +++ b/drivers/gpu/drm/i915/intel_lvds.c @@ -473,19 +473,13 @@ static enum drm_connector_status intel_lvds_detect(struct drm_connector *connector, bool force) { struct drm_device *dev = connector->dev; - enum drm_connector_status status = connector_status_connected; + enum drm_connector_status status; status = intel_panel_detect(dev); if (status != connector_status_unknown) return status; - /* ACPI lid methods were generally unreliable in this generation, so - * don't even bother. - */ - if (IS_GEN2(dev) || IS_GEN3(dev)) - return connector_status_connected; - - return status; + return connector_status_connected; } /** @@ -835,25 +829,6 @@ static bool lvds_is_present_in_vbt(struct drm_device *dev, return false; } -static bool intel_lvds_ddc_probe(struct drm_device *dev, u8 pin) -{ - struct drm_i915_private *dev_priv = dev->dev_private; - u8 buf = 0; - struct i2c_msg msgs[] = { - { - .addr = 0xA0, - .flags = 0, - .len = 1, - .buf = &buf, - }, - }; - struct i2c_adapter *i2c = &dev_priv->gmbus[pin].adapter; - /* XXX this only appears to work when using GMBUS */ - if (intel_gmbus_is_forced_bit(i2c)) - return true; - return i2c_transfer(i2c, msgs, 1) == 1; -} - /** * intel_lvds_init - setup LVDS connectors on this device * @dev: drm device @@ -894,11 +869,6 @@ bool intel_lvds_init(struct drm_device *dev) } } - if (!intel_lvds_ddc_probe(dev, pin)) { - DRM_DEBUG_KMS("LVDS did not respond to DDC probe\n"); - return false; - } - intel_lvds = kzalloc(sizeof(struct intel_lvds), GFP_KERNEL); if (!intel_lvds) { return false; diff --git a/drivers/gpu/drm/i915/intel_sdvo_regs.h b/drivers/gpu/drm/i915/intel_sdvo_regs.h index a386b022e538..4f4e23bc2d16 100644 --- a/drivers/gpu/drm/i915/intel_sdvo_regs.h +++ b/drivers/gpu/drm/i915/intel_sdvo_regs.h @@ -230,7 +230,7 @@ struct intel_sdvo_set_target_input_args { } __attribute__((packed)); /** - * Takes a struct intel_sdvo_output_flags of which outputs are targetted by + * Takes a struct intel_sdvo_output_flags of which outputs are targeted by * future output commands. * * Affected commands inclue SET_OUTPUT_TIMINGS_PART[12], |
