diff options
Diffstat (limited to 'arch/x86/kernel/smpboot.c')
| -rw-r--r-- | arch/x86/kernel/smpboot.c | 156 |
1 files changed, 128 insertions, 28 deletions
diff --git a/arch/x86/kernel/smpboot.c b/arch/x86/kernel/smpboot.c index c80a33bc528b..ed0fe385289d 100644 --- a/arch/x86/kernel/smpboot.c +++ b/arch/x86/kernel/smpboot.c @@ -68,6 +68,8 @@ #include <asm/mwait.h> #include <asm/apic.h> #include <asm/io_apic.h> +#include <asm/i387.h> +#include <asm/fpu-internal.h> #include <asm/setup.h> #include <asm/uv/uv.h> #include <linux/mc146818rtc.h> @@ -125,8 +127,8 @@ EXPORT_PER_CPU_SYMBOL(cpu_info); atomic_t init_deasserted; /* - * Report back to the Boot Processor. - * Running on AP. + * Report back to the Boot Processor during boot time or to the caller processor + * during CPU online. */ static void __cpuinit smp_callin(void) { @@ -138,15 +140,17 @@ static void __cpuinit smp_callin(void) * we may get here before an INIT-deassert IPI reaches * our local APIC. We have to wait for the IPI or we'll * lock up on an APIC access. + * + * Since CPU0 is not wakened up by INIT, it doesn't wait for the IPI. */ - if (apic->wait_for_init_deassert) + cpuid = smp_processor_id(); + if (apic->wait_for_init_deassert && cpuid != 0) apic->wait_for_init_deassert(&init_deasserted); /* * (This works even if the APIC is not enabled.) */ phys_id = read_apic_id(); - cpuid = smp_processor_id(); if (cpumask_test_cpu(cpuid, cpu_callin_mask)) { panic("%s: phys CPU#%d, CPU#%d already present??\n", __func__, phys_id, cpuid); @@ -228,6 +232,8 @@ static void __cpuinit smp_callin(void) cpumask_set_cpu(cpuid, cpu_callin_mask); } +static int cpu0_logical_apicid; +static int enable_start_cpu0; /* * Activate a secondary processor. */ @@ -243,6 +249,8 @@ notrace static void __cpuinit start_secondary(void *unused) preempt_disable(); smp_callin(); + enable_start_cpu0 = 0; + #ifdef CONFIG_X86_32 /* switch away from the initial page table */ load_cr3(swapper_pg_dir); @@ -279,19 +287,30 @@ notrace static void __cpuinit start_secondary(void *unused) cpu_idle(); } +void __init smp_store_boot_cpu_info(void) +{ + int id = 0; /* CPU 0 */ + struct cpuinfo_x86 *c = &cpu_data(id); + + *c = boot_cpu_data; + c->cpu_index = id; +} + /* * The bootstrap kernel entry code has set these up. Save them for * a given CPU */ - void __cpuinit smp_store_cpu_info(int id) { struct cpuinfo_x86 *c = &cpu_data(id); *c = boot_cpu_data; c->cpu_index = id; - if (id != 0) - identify_secondary_cpu(c); + /* + * During boot time, CPU0 has this setup already. Save the info when + * bringing up AP or offlined CPU0. + */ + identify_secondary_cpu(c); } static bool __cpuinit @@ -313,7 +332,7 @@ do { \ static bool __cpuinit match_smt(struct cpuinfo_x86 *c, struct cpuinfo_x86 *o) { - if (cpu_has(c, X86_FEATURE_TOPOEXT)) { + if (cpu_has_topoext) { int cpu1 = c->cpu_index, cpu2 = o->cpu_index; if (c->phys_proc_id == o->phys_proc_id && @@ -481,7 +500,7 @@ void __inquire_remote_apic(int apicid) * won't ... remember to clear down the APIC, etc later. */ int __cpuinit -wakeup_secondary_cpu_via_nmi(int logical_apicid, unsigned long start_eip) +wakeup_secondary_cpu_via_nmi(int apicid, unsigned long start_eip) { unsigned long send_status, accept_status = 0; int maxlvt; @@ -489,7 +508,7 @@ wakeup_secondary_cpu_via_nmi(int logical_apicid, unsigned long start_eip) /* Target chip */ /* Boot on the stack */ /* Kick the second */ - apic_icr_write(APIC_DM_NMI | apic->dest_logical, logical_apicid); + apic_icr_write(APIC_DM_NMI | apic->dest_logical, apicid); pr_debug("Waiting for send to finish...\n"); send_status = safe_apic_wait_icr_idle(); @@ -649,6 +668,63 @@ static void __cpuinit announce_cpu(int cpu, int apicid) node, cpu, apicid); } +static int wakeup_cpu0_nmi(unsigned int cmd, struct pt_regs *regs) +{ + int cpu; + + cpu = smp_processor_id(); + if (cpu == 0 && !cpu_online(cpu) && enable_start_cpu0) + return NMI_HANDLED; + + return NMI_DONE; +} + +/* + * Wake up AP by INIT, INIT, STARTUP sequence. + * + * Instead of waiting for STARTUP after INITs, BSP will execute the BIOS + * boot-strap code which is not a desired behavior for waking up BSP. To + * void the boot-strap code, wake up CPU0 by NMI instead. + * + * This works to wake up soft offlined CPU0 only. If CPU0 is hard offlined + * (i.e. physically hot removed and then hot added), NMI won't wake it up. + * We'll change this code in the future to wake up hard offlined CPU0 if + * real platform and request are available. + */ +static int __cpuinit +wakeup_cpu_via_init_nmi(int cpu, unsigned long start_ip, int apicid, + int *cpu0_nmi_registered) +{ + int id; + int boot_error; + + /* + * Wake up AP by INIT, INIT, STARTUP sequence. + */ + if (cpu) + return wakeup_secondary_cpu_via_init(apicid, start_ip); + + /* + * Wake up BSP by nmi. + * + * Register a NMI handler to help wake up CPU0. + */ + boot_error = register_nmi_handler(NMI_LOCAL, + wakeup_cpu0_nmi, 0, "wake_cpu0"); + + if (!boot_error) { + enable_start_cpu0 = 1; + *cpu0_nmi_registered = 1; + if (apic->dest_logical == APIC_DEST_LOGICAL) + id = cpu0_logical_apicid; + else + id = apicid; + boot_error = wakeup_secondary_cpu_via_nmi(id, start_ip); + } + + return boot_error; +} + /* * NOTE - on most systems this is a PHYSICAL apic ID, but on multiquad * (ie clustered apic addressing mode), this is a LOGICAL apic ID. @@ -664,6 +740,7 @@ static int __cpuinit do_boot_cpu(int apicid, int cpu, struct task_struct *idle) unsigned long boot_error = 0; int timeout; + int cpu0_nmi_registered = 0; /* Just in case we booted with a single CPU. */ alternatives_enable_smp(); @@ -711,13 +788,16 @@ static int __cpuinit do_boot_cpu(int apicid, int cpu, struct task_struct *idle) } /* - * Kick the secondary CPU. Use the method in the APIC driver - * if it's defined - or use an INIT boot APIC message otherwise: + * Wake up a CPU in difference cases: + * - Use the method in the APIC driver if it's defined + * Otherwise, + * - Use an INIT boot APIC message for APs or NMI for BSP. */ if (apic->wakeup_secondary_cpu) boot_error = apic->wakeup_secondary_cpu(apicid, start_ip); else - boot_error = wakeup_secondary_cpu_via_init(apicid, start_ip); + boot_error = wakeup_cpu_via_init_nmi(cpu, start_ip, apicid, + &cpu0_nmi_registered); if (!boot_error) { /* @@ -782,6 +862,13 @@ static int __cpuinit do_boot_cpu(int apicid, int cpu, struct task_struct *idle) */ smpboot_restore_warm_reset_vector(); } + /* + * Clean up the nmi handler. Do this after the callin and callout sync + * to avoid impact of possible long unregister time. + */ + if (cpu0_nmi_registered) + unregister_nmi_handler(NMI_LOCAL, "wake_cpu0"); + return boot_error; } @@ -795,7 +882,7 @@ int __cpuinit native_cpu_up(unsigned int cpu, struct task_struct *tidle) pr_debug("++++++++++++++++++++=_---CPU UP %u\n", cpu); - if (apicid == BAD_APICID || apicid == boot_cpu_physical_apicid || + if (apicid == BAD_APICID || !physid_isset(apicid, phys_cpu_present_map) || !apic->apic_id_valid(apicid)) { pr_err("%s: bad cpu %d\n", __func__, cpu); @@ -818,6 +905,9 @@ int __cpuinit native_cpu_up(unsigned int cpu, struct task_struct *tidle) per_cpu(cpu_state, cpu) = CPU_UP_PREPARE; + /* the FPU context is blank, nobody can own it */ + __cpu_disable_lazy_restore(cpu); + err = do_boot_cpu(apicid, cpu, tidle); if (err) { pr_debug("do_boot_cpu failed %d\n", err); @@ -990,7 +1080,7 @@ void __init native_smp_prepare_cpus(unsigned int max_cpus) /* * Setup boot CPU information */ - smp_store_cpu_info(0); /* Final full version of the data */ + smp_store_boot_cpu_info(); /* Final full version of the data */ cpumask_copy(cpu_callin_mask, cpumask_of(0)); mb(); @@ -1026,6 +1116,11 @@ void __init native_smp_prepare_cpus(unsigned int max_cpus) */ setup_local_APIC(); + if (x2apic_mode) + cpu0_logical_apicid = apic_read(APIC_LDR); + else + cpu0_logical_apicid = GET_APIC_LOGICAL_ID(apic_read(APIC_LDR)); + /* * Enable IO APIC before setting up error vector */ @@ -1214,19 +1309,6 @@ void cpu_disable_common(void) int native_cpu_disable(void) { - int cpu = smp_processor_id(); - - /* - * Perhaps use cpufreq to drop frequency, but that could go - * into generic code. - * - * We won't take down the boot processor on i386 due to some - * interrupts only being able to be serviced by the BSP. - * Especially so if we're not using an IOAPIC -zwane - */ - if (cpu == 0) - return -EBUSY; - clear_local_APIC(); cpu_disable_common(); @@ -1266,6 +1348,14 @@ void play_dead_common(void) local_irq_disable(); } +static bool wakeup_cpu0(void) +{ + if (smp_processor_id() == 0 && enable_start_cpu0) + return true; + + return false; +} + /* * We need to flush the caches before going to sleep, lest we have * dirty data in our caches when we come back up. @@ -1329,6 +1419,11 @@ static inline void mwait_play_dead(void) __monitor(mwait_ptr, 0, 0); mb(); __mwait(eax, 0); + /* + * If NMI wants to wake up CPU0, start CPU0. + */ + if (wakeup_cpu0()) + start_cpu0(); } } @@ -1339,6 +1434,11 @@ static inline void hlt_play_dead(void) while (1) { native_halt(); + /* + * If NMI wants to wake up CPU0, start CPU0. + */ + if (wakeup_cpu0()) + start_cpu0(); } } |
