diff options
Diffstat (limited to 'arch/blackfin/mach-bf518')
| -rw-r--r-- | arch/blackfin/mach-bf518/Kconfig | 1 | ||||
| -rw-r--r-- | arch/blackfin/mach-bf518/boards/ezbrd.c | 19 | ||||
| -rw-r--r-- | arch/blackfin/mach-bf518/include/mach/anomaly.h | 35 | ||||
| -rw-r--r-- | arch/blackfin/mach-bf518/include/mach/portmux.h | 6 |
4 files changed, 52 insertions, 9 deletions
diff --git a/arch/blackfin/mach-bf518/Kconfig b/arch/blackfin/mach-bf518/Kconfig index f397ede006bf..4c76fefb7a3b 100644 --- a/arch/blackfin/mach-bf518/Kconfig +++ b/arch/blackfin/mach-bf518/Kconfig @@ -156,6 +156,7 @@ config IRQ_PORTH_INTB default 11 config IRQ_TIMER0 int "IRQ_TIMER0" + default 7 if TICKSOURCE_GPTMR0 default 8 config IRQ_TIMER1 int "IRQ_TIMER1" diff --git a/arch/blackfin/mach-bf518/boards/ezbrd.c b/arch/blackfin/mach-bf518/boards/ezbrd.c index 41f2eacfef20..62bba09bcce6 100644 --- a/arch/blackfin/mach-bf518/boards/ezbrd.c +++ b/arch/blackfin/mach-bf518/boards/ezbrd.c @@ -82,7 +82,11 @@ static struct physmap_flash_data ezbrd_flash_data = { static struct resource ezbrd_flash_resource = { .start = 0x20000000, +#if defined(CONFIG_SPI_BFIN) || defined(CONFIG_SPI_BFIN_MODULE) + .end = 0x202fffff, +#else .end = 0x203fffff, +#endif .flags = IORESOURCE_MEM, }; @@ -162,8 +166,8 @@ static struct bfin5xx_spi_chip spi_flash_chip_info = { }; #endif -#if defined(CONFIG_SPI_ADC_BF533) \ - || defined(CONFIG_SPI_ADC_BF533_MODULE) +#if defined(CONFIG_BFIN_SPI_ADC) \ + || defined(CONFIG_BFIN_SPI_ADC_MODULE) /* SPI ADC chip */ static struct bfin5xx_spi_chip spi_adc_chip_info = { .enable_dma = 1, /* use dma transfer with this chip*/ @@ -249,8 +253,8 @@ static struct spi_board_info bfin_spi_board_info[] __initdata = { }, #endif -#if defined(CONFIG_SPI_ADC_BF533) \ - || defined(CONFIG_SPI_ADC_BF533_MODULE) +#if defined(CONFIG_BFIN_SPI_ADC) \ + || defined(CONFIG_BFIN_SPI_ADC_MODULE) { .modalias = "bfin_spi_adc", /* Name of spi_driver for this device */ .max_speed_hz = 6250000, /* max spi clock (SCK) speed in HZ */ @@ -514,7 +518,7 @@ static struct platform_device i2c_bfin_twi_device = { #endif static struct i2c_board_info __initdata bfin_i2c_board_info[] = { -#if defined(CONFIG_TWI_LCD) || defined(CONFIG_TWI_LCD_MODULE) +#if defined(CONFIG_BFIN_TWI_LCD) || defined(CONFIG_TWI_LCD_MODULE) { I2C_BOARD_INFO("pcf8574_lcd", 0x22), }, @@ -678,6 +682,11 @@ static int __init ezbrd_init(void) ARRAY_SIZE(bfin_i2c_board_info)); platform_add_devices(stamp_devices, ARRAY_SIZE(stamp_devices)); spi_register_board_info(bfin_spi_board_info, ARRAY_SIZE(bfin_spi_board_info)); + /* setup BF518-EZBRD GPIO pin PG11 to AMS2, PG15 to AMS3. */ + peripheral_request(P_AMS2, "ParaFlash"); +#if !defined(CONFIG_SPI_BFIN) && !defined(CONFIG_SPI_BFIN_MODULE) + peripheral_request(P_AMS3, "ParaFlash"); +#endif return 0; } diff --git a/arch/blackfin/mach-bf518/include/mach/anomaly.h b/arch/blackfin/mach-bf518/include/mach/anomaly.h index c847bb101076..b69bd9af38dd 100644 --- a/arch/blackfin/mach-bf518/include/mach/anomaly.h +++ b/arch/blackfin/mach-bf518/include/mach/anomaly.h @@ -6,14 +6,19 @@ * Licensed under the GPL-2 or later. */ -/* This file shoule be up to date with: +/* This file should be up to date with: * - Revision B, 02/03/2009; ADSP-BF512/BF514/BF516/BF518 Blackfin Processor Anomaly List */ +/* We plan on not supporting 0.0 silicon, but 0.1 isn't out yet - sorry */ +#if __SILICON_REVISION__ < 0 +# error will not work on BF518 silicon version +#endif + #ifndef _MACH_ANOMALY_H_ #define _MACH_ANOMALY_H_ -/* Multi-Issue Instruction with dsp32shiftimm in slot1 and P-reg Store in slot2 Not Supported */ +/* Multi-issue instruction with dsp32shiftimm in slot1 and P-reg store in slot 2 not supported */ #define ANOMALY_05000074 (1) /* Rx.H Cannot Be Used to Access 16-bit System MMR Registers */ #define ANOMALY_05000122 (1) @@ -47,7 +52,7 @@ #define ANOMALY_05000435 (1) /* PORTx_DRIVE and PORTx_HYSTERESIS Registers Read Back Incorrect Values */ #define ANOMALY_05000438 (1) -/* Preboot Cannot be Used to Program the PLL_DIV Register */ +/* Preboot Cannot be Used to Alter the PLL_DIV Register */ #define ANOMALY_05000439 (1) /* bfrom_SysControl() Cannot be Used to Write the PLL_DIV Register */ #define ANOMALY_05000440 (1) @@ -61,32 +66,56 @@ #define ANOMALY_05000453 (1) /* PPI_FS3 is Driven One Half Cycle Later Than PPI Data */ #define ANOMALY_05000455 (1) +/* False Hardware Error when RETI points to invalid memory */ +#define ANOMALY_05000461 (1) /* Anomalies that don't exist on this proc */ +#define ANOMALY_05000099 (0) +#define ANOMALY_05000119 (0) +#define ANOMALY_05000120 (0) #define ANOMALY_05000125 (0) +#define ANOMALY_05000149 (0) #define ANOMALY_05000158 (0) +#define ANOMALY_05000171 (0) +#define ANOMALY_05000179 (0) #define ANOMALY_05000183 (0) #define ANOMALY_05000198 (0) +#define ANOMALY_05000215 (0) +#define ANOMALY_05000220 (0) +#define ANOMALY_05000227 (0) #define ANOMALY_05000230 (0) +#define ANOMALY_05000231 (0) +#define ANOMALY_05000233 (0) +#define ANOMALY_05000242 (0) #define ANOMALY_05000244 (0) +#define ANOMALY_05000248 (0) +#define ANOMALY_05000250 (0) #define ANOMALY_05000261 (0) #define ANOMALY_05000263 (0) #define ANOMALY_05000266 (0) #define ANOMALY_05000273 (0) +#define ANOMALY_05000274 (0) #define ANOMALY_05000278 (0) #define ANOMALY_05000285 (0) +#define ANOMALY_05000287 (0) +#define ANOMALY_05000301 (0) #define ANOMALY_05000305 (0) #define ANOMALY_05000307 (0) #define ANOMALY_05000311 (0) #define ANOMALY_05000312 (0) #define ANOMALY_05000323 (0) #define ANOMALY_05000353 (0) +#define ANOMALY_05000362 (1) #define ANOMALY_05000363 (0) #define ANOMALY_05000380 (0) #define ANOMALY_05000386 (0) +#define ANOMALY_05000389 (0) +#define ANOMALY_05000400 (0) #define ANOMALY_05000412 (0) #define ANOMALY_05000432 (0) #define ANOMALY_05000447 (0) #define ANOMALY_05000448 (0) +#define ANOMALY_05000456 (0) +#define ANOMALY_05000450 (0) #endif diff --git a/arch/blackfin/mach-bf518/include/mach/portmux.h b/arch/blackfin/mach-bf518/include/mach/portmux.h index f618b487b2b0..a0fc77fd3315 100644 --- a/arch/blackfin/mach-bf518/include/mach/portmux.h +++ b/arch/blackfin/mach-bf518/include/mach/portmux.h @@ -185,6 +185,10 @@ #define P_PTP_PPS (P_DEFINED | P_IDENT(GPIO_PG12) | P_FUNCT(2)) #define P_PTP_CLKOUT (P_DEFINED | P_IDENT(GPIO_PG13) | P_FUNCT(2)) -#define P_HWAIT (P_DEFINED | P_IDENT(GPIO_PG000000000) | P_FUNCT(1)) +/* AMS */ +#define P_AMS2 (P_DEFINED | P_IDENT(GPIO_PG11) | P_FUNCT(1)) +#define P_AMS3 (P_DEFINED | P_IDENT(GPIO_PG15) | P_FUNCT(2)) + +#define P_HWAIT (P_DEFINED | P_IDENT(GPIO_PG000000000) | P_FUNCT(1)) #endif /* _MACH_PORTMUX_H_ */ |
