diff options
Diffstat (limited to 'arch/arm/boot/dts/sun6i-a31.dtsi')
| -rw-r--r-- | arch/arm/boot/dts/sun6i-a31.dtsi | 92 |
1 files changed, 90 insertions, 2 deletions
diff --git a/arch/arm/boot/dts/sun6i-a31.dtsi b/arch/arm/boot/dts/sun6i-a31.dtsi index a9dfa12eb735..44b07e512c24 100644 --- a/arch/arm/boot/dts/sun6i-a31.dtsi +++ b/arch/arm/boot/dts/sun6i-a31.dtsi @@ -23,6 +23,7 @@ serial3 = &uart3; serial4 = &uart4; serial5 = &uart5; + ethernet0 = &gmac; }; @@ -281,6 +282,34 @@ "usb_ohci0", "usb_ohci1", "usb_ohci2"; }; + + /* + * The following two are dummy clocks, placeholders used in the gmac_tx + * clock. The gmac driver will choose one parent depending on the PHY + * interface mode, using clk_set_rate auto-reparenting. + * The actual TX clock rate is not controlled by the gmac_tx clock. + */ + mii_phy_tx_clk: clk@1 { + #clock-cells = <0>; + compatible = "fixed-clock"; + clock-frequency = <25000000>; + clock-output-names = "mii_phy_tx"; + }; + + gmac_int_tx_clk: clk@2 { + #clock-cells = <0>; + compatible = "fixed-clock"; + clock-frequency = <125000000>; + clock-output-names = "gmac_int_tx"; + }; + + gmac_tx_clk: clk@01c200d0 { + #clock-cells = <0>; + compatible = "allwinner,sun7i-a20-gmac-clk"; + reg = <0x01c200d0 0x4>; + clocks = <&mii_phy_tx_clk>, <&gmac_int_tx_clk>; + clock-output-names = "gmac_tx"; + }; }; soc@01c00000 { @@ -429,7 +458,7 @@ clocks = <&apb1_gates 5>; gpio-controller; interrupt-controller; - #address-cells = <1>; + #interrupt-cells = <2>; #size-cells = <0>; #gpio-cells = <3>; @@ -467,6 +496,48 @@ allwinner,drive = <2>; allwinner,pull = <0>; }; + + gmac_pins_mii_a: gmac_mii@0 { + allwinner,pins = "PA0", "PA1", "PA2", "PA3", + "PA8", "PA9", "PA11", + "PA12", "PA13", "PA14", "PA19", + "PA20", "PA21", "PA22", "PA23", + "PA24", "PA26", "PA27"; + allwinner,function = "gmac"; + allwinner,drive = <0>; + allwinner,pull = <0>; + }; + + gmac_pins_gmii_a: gmac_gmii@0 { + allwinner,pins = "PA0", "PA1", "PA2", "PA3", + "PA4", "PA5", "PA6", "PA7", + "PA8", "PA9", "PA10", "PA11", + "PA12", "PA13", "PA14", "PA15", + "PA16", "PA17", "PA18", "PA19", + "PA20", "PA21", "PA22", "PA23", + "PA24", "PA25", "PA26", "PA27"; + allwinner,function = "gmac"; + /* + * data lines in GMII mode run at 125MHz and + * might need a higher signal drive strength + */ + allwinner,drive = <2>; + allwinner,pull = <0>; + }; + + gmac_pins_rgmii_a: gmac_rgmii@0 { + allwinner,pins = "PA0", "PA1", "PA2", "PA3", + "PA9", "PA10", "PA11", + "PA12", "PA13", "PA14", "PA19", + "PA20", "PA25", "PA26", "PA27"; + allwinner,function = "gmac"; + /* + * data lines in RGMII mode use DDR mode + * and need a higher signal drive strength + */ + allwinner,drive = <3>; + allwinner,pull = <0>; + }; }; ahb1_rst: reset@01c202c0 { @@ -621,6 +692,23 @@ status = "disabled"; }; + gmac: ethernet@01c30000 { + compatible = "allwinner,sun7i-a20-gmac"; + reg = <0x01c30000 0x1054>; + interrupts = <0 82 4>; + interrupt-names = "macirq"; + clocks = <&ahb1_gates 17>, <&gmac_tx_clk>; + clock-names = "stmmaceth", "allwinner_gmac_tx"; + resets = <&ahb1_rst 17>; + reset-names = "stmmaceth"; + snps,pbl = <2>; + snps,fixed-burst; + snps,force_sf_dma_mode; + status = "disabled"; + #address-cells = <1>; + #size-cells = <0>; + }; + timer@01c60000 { compatible = "allwinner,sun6i-a31-hstimer", "allwinner,sun7i-a20-hstimer"; reg = <0x01c60000 0x1000>; @@ -756,7 +844,7 @@ resets = <&apb0_rst 0>; gpio-controller; interrupt-controller; - #address-cells = <1>; + #interrupt-cells = <2>; #size-cells = <0>; #gpio-cells = <3>; }; |
