diff options
| -rw-r--r-- | arch/powerpc/platforms/pseries/eeh.c | 110 | ||||
| -rw-r--r-- | include/asm-powerpc/ppc-pci.h | 3 |
2 files changed, 61 insertions, 52 deletions
diff --git a/arch/powerpc/platforms/pseries/eeh.c b/arch/powerpc/platforms/pseries/eeh.c index cb8a151bc9e7..c4604f71c962 100644 --- a/arch/powerpc/platforms/pseries/eeh.c +++ b/arch/powerpc/platforms/pseries/eeh.c @@ -76,6 +76,9 @@ */ #define EEH_MAX_FAILS 2100000 +/* Time to wait for a PCI slot to retport status, in milliseconds */ +#define PCI_BUS_RESET_WAIT_MSEC (60*1000) + /* RTAS tokens */ static int ibm_set_eeh_option; static int ibm_set_slot_reset; @@ -169,6 +172,55 @@ static int read_slot_reset_state(struct pci_dn *pdn, int rets[]) } /** + * eeh_wait_for_slot_status - returns error status of slot + * @pdn pci device node + * @max_wait_msecs maximum number to millisecs to wait + * + * Return negative value if a permanent error, else return + * Partition Endpoint (PE) status value. + * + * If @max_wait_msecs is positive, then this routine will + * sleep until a valid status can be obtained, or until + * the max allowed wait time is exceeded, in which case + * a -2 is returned. + */ +int +eeh_wait_for_slot_status(struct pci_dn *pdn, int max_wait_msecs) +{ + int rc; + int rets[3]; + int mwait; + + while (1) { + rc = read_slot_reset_state(pdn, rets); + if (rc) return rc; + if (rets[1] == 0) return -1; /* EEH is not supported */ + + if (rets[0] != 5) return rets[0]; /* return actual status */ + + if (rets[2] == 0) return -1; /* permanently unavailable */ + + if (max_wait_msecs <= 0) return -1; + + mwait = rets[2]; + if (mwait <= 0) { + printk (KERN_WARNING + "EEH: Firmware returned bad wait value=%d\n", mwait); + mwait = 1000; + } else if (mwait > 300*1000) { + printk (KERN_WARNING + "EEH: Firmware is taking too long, time=%d\n", mwait); + mwait = 300*1000; + } + max_wait_msecs -= mwait; + msleep (mwait); + } + + printk(KERN_WARNING "EEH: Timed out waiting for slot status\n"); + return -2; +} + +/** * eeh_token_to_phys - convert EEH address token to phys address * @token i/o token, should be address in the form 0xA.... */ @@ -459,38 +511,6 @@ EXPORT_SYMBOL(eeh_check_failure); /* The code below deals with error recovery */ /** - * eeh_slot_availability - returns error status of slot - * @pdn pci device node - * - * Return negative value if a permanent error, else return - * a number of milliseconds to wait until the PCI slot is - * ready to be used. - */ -static int -eeh_slot_availability(struct pci_dn *pdn) -{ - int rc; - int rets[3]; - - rc = read_slot_reset_state(pdn, rets); - - if (rc) return rc; - - if (rets[1] == 0) return -1; /* EEH is not supported */ - if (rets[0] == 0) return 0; /* Oll Korrect */ - if (rets[0] == 5) { - if (rets[2] == 0) return -1; /* permanently unavailable */ - return rets[2]; /* number of millisecs to wait */ - } - if (rets[0] == 1) - return 250; - - printk (KERN_ERR "EEH: Slot unavailable: rc=%d, rets=%d %d %d\n", - rc, rets[0], rets[1], rets[2]); - return -2; -} - -/** * rtas_pci_enable - enable MMIO or DMA transfers for this slot * @pdn pci device node */ @@ -596,36 +616,24 @@ int rtas_set_slot_reset(struct pci_dn *pdn) { int i, rc; - __rtas_set_slot_reset(pdn); + /* Take three shots at resetting the bus */ + for (i=0; i<3; i++) { + __rtas_set_slot_reset(pdn); - /* Now double check with the firmware to make sure the device is - * ready to be used; if not, wait for recovery. */ - for (i=0; i<10; i++) { - rc = eeh_slot_availability (pdn); + rc = eeh_wait_for_slot_status(pdn, PCI_BUS_RESET_WAIT_MSEC); if (rc == 0) return 0; - if (rc == -2) { - printk (KERN_ERR "EEH: failed (%d) to reset slot %s\n", - i, pdn->node->full_name); - __rtas_set_slot_reset(pdn); - continue; - } - if (rc < 0) { printk (KERN_ERR "EEH: unrecoverable slot failure %s\n", pdn->node->full_name); return -1; } - - msleep (rc+100); + printk (KERN_ERR "EEH: bus reset %d failed on slot %s\n", + i+1, pdn->node->full_name); } - rc = eeh_slot_availability (pdn); - if (rc) - printk (KERN_ERR "EEH: timeout resetting slot %s\n", pdn->node->full_name); - - return rc; + return -1; } /* ------------------------------------------------------- */ diff --git a/include/asm-powerpc/ppc-pci.h b/include/asm-powerpc/ppc-pci.h index f186720d0739..d74b2965bb82 100644 --- a/include/asm-powerpc/ppc-pci.h +++ b/include/asm-powerpc/ppc-pci.h @@ -70,7 +70,7 @@ struct pci_dev *pci_get_device_by_addr(unsigned long addr); void eeh_slot_error_detail (struct pci_dn *pdn, int severity); /** - * rtas_pci_enableo - enable IO transfers for this slot + * rtas_pci_enable - enable IO transfers for this slot * @pdn: pci device node * @function: either EEH_THAW_MMIO or EEH_THAW_DMA * @@ -91,6 +91,7 @@ int rtas_pci_enable(struct pci_dn *pdn, int function); * Returns a non-zero value if the reset failed. */ int rtas_set_slot_reset (struct pci_dn *); +int eeh_wait_for_slot_status(struct pci_dn *pdn, int max_wait_msecs); /** * eeh_restore_bars - Restore device configuration info. |
