[media] rc-core: remove protocol arrays

The basic API of rc-core used to be:

	dev = rc_allocate_device();
	dev->x = a;
	dev->y = b;
	dev->z = c;
	rc_register_device();

which is a pretty common pattern in the kernel, after the introduction of
protocol arrays the API looks something like:

	dev = rc_allocate_device();
	dev->x = a;
	rc_set_allowed_protocols(dev, RC_BIT_X);
	dev->z = c;
	rc_register_device();

There's no real need for the protocols to be an array, so change it
back to be consistent (and in preparation for the following patches).

[m.chehab@samsung.com: added missing changes at some files]
Signed-off-by: David Härdeman <david@hardeman.nu>
Signed-off-by: Mauro Carvalho Chehab <m.chehab@samsung.com>

1 files changed, 3 insertions, 3 deletions

diff --git a/drivers/media/rc/ir-rc5-decoder.c b/drivers/media/rc/ir-rc5-decoder.c
index 3d38cbce5667..04ce42fa9eec 100644
--- a/drivers/media/rc/ir-rc5-decoder.c
+++ b/drivers/media/rc/ir-rc5-decoder.c
@@ -53,7 +53,7 @@ static int ir_rc5_decode(struct rc_dev *dev, struct ir_raw_event ev)
 	u32 scancode;
 	enum rc_type protocol;
 
-	if (!rc_protocols_enabled(dev, RC_BIT_RC5 | RC_BIT_RC5X))
+	if (!(dev->enabled_protocols & (RC_BIT_RC5 | RC_BIT_RC5X)))
 		return 0;
 
 	if (!is_timing_event(ev)) {
@@ -129,7 +129,7 @@ again:
 		if (data->wanted_bits == RC5X_NBITS) {
 			/* RC5X */
 			u8 xdata, command, system;
-			if (!rc_protocols_enabled(dev, RC_BIT_RC5X)) {
+			if (!(dev->enabled_protocols & RC_BIT_RC5X)) {
 				data->state = STATE_INACTIVE;
 				return 0;
 			}
@@ -147,7 +147,7 @@ again:
 		} else {
 			/* RC5 */
 			u8 command, system;
-			if (!rc_protocols_enabled(dev, RC_BIT_RC5)) {
+			if (!(dev->enabled_protocols & RC_BIT_RC5)) {
 				data->state = STATE_INACTIVE;
 				return 0;
 			}