diff options
| author | Hans-Christian Egtvedt <hans-christian.egtvedt@atmel.com> | 2008-07-01 08:29:27 +0000 |
|---|---|---|
| committer | Haavard Skinnemoen <haavard.skinnemoen@atmel.com> | 2008-10-13 12:56:24 +0200 |
| commit | a3bee42f058c2f9fe281df942eff397924630a12 (patch) | |
| tree | 81bd43eddc01ab40958382c542aafef6a4892328 /arch/avr32/boards/atngw100/setup.c | |
| parent | 1d3ba686ed706a0e8563878b2ec415e125178607 (diff) | |
| download | blackbird-op-linux-a3bee42f058c2f9fe281df942eff397924630a12.tar.gz blackbird-op-linux-a3bee42f058c2f9fe281df942eff397924630a12.zip | |
avr32: Add support for EVKLCD10X addon boards
This patch lets the user enable support for EVKLCD100 and EVKLCD101
(refered to by EVKLCD10X). By enabling EVKLCD10X support the LCD
controller and AC97 controller platform devices are added.
The user can also choose between the EVKLCD100 (QVGA display) and the
EVKLCD101 (VGA display), this is added to automagically select the
correct panel timing and resolution parameters.
Enabling support for EVKLCD10X addon board will cripple the MCI platform
device a bit since they share two GPIO lines (detect and write-protect).
These two lines are disabled when EVKLCD10X is enabled.
The default configurations are based upon ATNGW100, but with added AC97C
and LCDC driver. Virtual terminal is also enabled by default for
EVKLCD10X boards.
Verified on hardware with a NGW100 + EVKLCD100/101.
Signed-off-by: Hans-Christian Egtvedt <hans-christian.egtvedt@atmel.com>
Signed-off-by: Haavard Skinnemoen <haavard.skinnemoen@atmel.com>
Diffstat (limited to 'arch/avr32/boards/atngw100/setup.c')
| -rw-r--r-- | arch/avr32/boards/atngw100/setup.c | 5 |
1 files changed, 5 insertions, 0 deletions
diff --git a/arch/avr32/boards/atngw100/setup.c b/arch/avr32/boards/atngw100/setup.c index 6c54580a66df..af38ab3e4502 100644 --- a/arch/avr32/boards/atngw100/setup.c +++ b/arch/avr32/boards/atngw100/setup.c @@ -56,8 +56,13 @@ static struct spi_board_info spi0_board_info[] __initdata = { static struct mci_platform_data __initdata mci0_data = { .slot[0] = { .bus_width = 4, +#ifndef CONFIG_BOARD_ATNGW100_EVKLCD10X .detect_pin = GPIO_PIN_PC(25), .wp_pin = GPIO_PIN_PE(0), +#else + .detect_pin = GPIO_PIN_NONE, + .wp_pin = GPIO_PIN_NONE, +#endif }, }; |
