ARM: imx: ensure dsm_request signal is not asserted when setting LPM

There is a defect in imx6 LPM design.  When SW tries to enter low power
mode with following sequence, the chip will enter low power mode before
A9 CPU execute WFI instruction:

1. Set CCM_CLPCR[1:0] to 2'b00;
2. ARM CPU enters WFI;
3. ARM CPU wakeup from an interrupt event, which is masked by GPC or not
   visible to GPC, such as interrupt from local timer;
4. Set CCM_CLPCR[1:0] to 2'b01 or 2'b10;
5. ARM CPU execute WFI.

Before the last step, the chip will enter WAIT mode if CCM_CLPCR[1:0] is
set to 2'b01, or enter STOP mode if CCM_CLPCR[1:0] is set to 2'b10.

The patch implements a recommended workaround for this issue.

1. SW triggers irq #32(IOMUX) to be always pending manually by setting
   IOMUX_GPR1_GINT bit;
2. SW should then unmask it in GPC before setting CCM LPM;
3. SW should mask it right after CCM LPM is set (bit0-1 of CCM_CLPCR).

Signed-off-by: Shawn Guo <shawn.guo@linaro.org>

1 files changed, 3 insertions, 0 deletions

diff --git a/arch/arm/mach-imx/common.h b/arch/arm/mach-imx/common.h
index fde6661ef70d..7cbe22d0c6e9 100644
--- a/arch/arm/mach-imx/common.h
+++ b/arch/arm/mach-imx/common.h
@@ -13,6 +13,7 @@
 
 #include <linux/reboot.h>
 
+struct irq_data;
 struct platform_device;
 struct pt_regs;
 struct clk;
@@ -136,6 +137,8 @@ void imx_gpc_pre_suspend(void);
 void imx_gpc_post_resume(void);
 void imx_gpc_mask_all(void);
 void imx_gpc_restore_all(void);
+void imx_gpc_irq_mask(struct irq_data *d);
+void imx_gpc_irq_unmask(struct irq_data *d);
 void imx_anatop_init(void);
 void imx_anatop_pre_suspend(void);
 void imx_anatop_post_resume(void);