Merge tag 'for-v4.3' of git://git.kernel.org/pub/scm/linux/kernel/git/sre/linux-power-supply

Pull power supply and reset changes from Sebastian Reichel:
 - new reset driver for ZTE SoCs
 - add support for sama5d3 reset handling
 - overhaul of twl4030 charger driver
 - misc fixes and cleanups

* tag 'for-v4.3' of git://git.kernel.org/pub/scm/linux/kernel/git/sre/linux-power-supply: (35 commits)
  bq2415x_charger: Allow to load and use driver even if notify device is not registered yet
  twl4030_charger: fix compile error when TWL4030_MADC not available.
  power: bq24190_charger: Fix charge type sysfs property
  power: Allow compile test of GPIO consumers if !GPIOLIB
  power: Export I2C module alias information in missing drivers
  twl4030_charger: Increase current carefully while watching voltage.
  twl4030_charger: add ac/mode to match usb/mode
  twl4030_charger: add software controlled linear charging mode.
  twl4030_charger: enable manual enable/disable of usb charging.
  twl4030_charger: allow max_current to be managed via sysfs.
  twl4030_charger: distinguish between USB current and 'AC' current
  twl4030_charger: allow fine control of charger current.
  twl4030_charger: split uA calculation into a function.
  twl4030_charger: trust phy to determine when USB power is available.
  twl4030_charger: correctly handle -EPROBE_DEFER from devm_usb_get_phy_by_node
  twl4030_charger: convert to module_platform_driver instead of ..._probe.
  twl4030_charger: use runtime_pm to keep usb phy active while charging.
  rx51-battery: Set name to rx51-battery
  MAINTAINERS: AVS is not maintained via power supply tree
  power: olpc_battery: clean up eeprom read function
  ...

2 files changed, 46 insertions, 1 deletions

diff --git a/Documentation/ABI/testing/sysfs-class-power-twl4030 b/Documentation/ABI/testing/sysfs-class-power-twl4030
new file mode 100644
index 000000000000..be26af0f1895
--- /dev/null
+++ b/Documentation/ABI/testing/sysfs-class-power-twl4030
@@ -0,0 +1,45 @@
+What: /sys/class/power_supply/twl4030_ac/max_current
+      /sys/class/power_supply/twl4030_usb/max_current
+Description:
+	Read/Write limit on current which may
+	be drawn from the ac (Accessory Charger) or
+	USB port.
+
+	Value is in micro-Amps.
+
+	Value is set automatically to an appropriate
+	value when a cable is plugged or unplugged.
+
+	Value can the set by writing to the attribute.
+	The change will only persist until the next
+	plug event.  These event are reported via udev.
+
+
+What: /sys/class/power_supply/twl4030_usb/mode
+Description:
+	Changing mode for USB port.
+	Writing to this can disable charging.
+
+	Possible values are:
+		"auto" - draw power as appropriate for detected
+			 power source and battery status.
+		"off"  - do not draw any power.
+		"continuous"
+		       - activate mode described as "linear" in
+		         TWL data sheets.  This uses whatever
+			 current is available and doesn't switch off
+			 when voltage drops.
+
+			 This is useful for unstable power sources
+			 such as bicycle dynamo, but care should
+			 be taken that battery is not over-charged.
+
+What: /sys/class/power_supply/twl4030_ac/mode
+Description:
+	Changing mode for 'ac' port.
+	Writing to this can disable charging.
+
+	Possible values are:
+		"auto" - draw power as appropriate for detected
+			 power source and battery status.
+		"off"  - do not draw any power.
diff --git a/Documentation/devicetree/bindings/arm/atmel-at91.txt b/Documentation/devicetree/bindings/arm/atmel-at91.txt
index 424ac8cbfa08..dd998b9c0433 100644
--- a/Documentation/devicetree/bindings/arm/atmel-at91.txt
+++ b/Documentation/devicetree/bindings/arm/atmel-at91.txt
@@ -87,7 +87,7 @@ One interrupt per TC channel in a TC block:
 
 RSTC Reset Controller required properties:
 - compatible: Should be "atmel,<chip>-rstc".
-  <chip> can be "at91sam9260" or "at91sam9g45"
+  <chip> can be "at91sam9260" or "at91sam9g45" or "sama5d3"
 - reg: Should contain registers location and length
 
 Example: