/* * (C) Copyright 2010-2012 * NVIDIA Corporation * * SPDX-License-Identifier: GPL-2.0+ */ #include #include #include #include #include #include #include #include #ifdef CONFIG_TEGRA_MMC /* * Routine: pin_mux_mmc * Description: setup the pin muxes/tristate values for the SDMMC(s) */ void pin_mux_mmc(void) { uchar val; int ret; /* Turn on MAX8907B LDO12 to 2.8V for J40 power */ ret = i2c_set_bus_num(0); if (ret) printf("i2c_set_bus_num failed: %d\n", ret); val = 0x29; ret = i2c_write(0x3c, 0x46, 1, &val, 1); if (ret) printf("i2c_write 0 0x3c 0x46 failed: %d\n", ret); val = 0x00; ret = i2c_write(0x3c, 0x45, 1, &val, 1); if (ret) printf("i2c_write 0 0x3c 0x45 failed: %d\n", ret); val = 0x1f; ret = i2c_write(0x3c, 0x44, 1, &val, 1); if (ret) printf("i2c_write 0 0x3c 0x44 failed: %d\n", ret); funcmux_select(PERIPH_ID_SDMMC3, FUNCMUX_SDMMC3_SDB_SLXA_8BIT); funcmux_select(PERIPH_ID_SDMMC4, FUNCMUX_SDMMC4_ATC_ATD_8BIT); } #endif /* this is a weak define that we are overriding */ void pin_mux_usb(void) { uchar val; int ret; /* * This is a hack. This should be represented in DT using the * vbus-gpio property. However, U-Boot's DT support doesn't * support any GPIO controller other than the Tegra's yet. */ /* Turn on TAC6416's GPIO 0+1 for USB1/3's VBUS */ ret = i2c_set_bus_num(0); if (ret) printf("i2c_set_bus_num failed: %d\n", ret); val = 0x03; ret = i2c_write(0x20, 2, 1, &val, 1); if (ret) printf("i2c_write 0 0x20 2 failed: %d\n", ret); val = 0xfc; ret = i2c_write(0x20, 6, 1, &val, 1); if (ret) printf("i2c_write 0 0x20 6 failed: %d\n", ret); }