This document describes the board support for Dil/NetPC DNP/5370 (http://www.dilnetpc.com/dnp0086.htm) module. The distributor is SSV (http://www.ssv-embedded.de), The module used to develop the support files contains: * Processor: Blackfin BF537 Rev 0.3 (600 MHz core / 120MHz RAM) * RAM: 32 MB SDRAM Hynix HY57V561620FTP-H 810EA Connected to Blackfin via "Expansion Bus" Address range 0x0000.0000 - 0x1fff.ffff * NOR flash: 32 MBit (4 MByte) Exel Semiconductor ES29LVS320EB Connected to Blackfin via "Expansion Bus", Chip Selects 0, 1 and 2, each is connected to a 1 MB memory bank at Blackfin, therefore only 3 MB accessible. Address range 0x2000.0000 - 0x202f.ffff CFI compatible Exel Semiconductor was bought by Rohm Semiconductor (www.rohm.com). * NAND flash: 64 MBit (8 MByte) Atmel 45DB642D-CNU Connected to Blackfin via SPI CFI compatible * Davicom DM9161EP Ethernet PHY * A SD card reader, connected via SPI * Hardware watchdog MAX823 or TPS3823 (other devices not listed here) To run it, the module must be inserted in a 64 pin DIL socket on another board, e.g. DNP/EVA13 (together: SSV SK28). The Blackfin is booted from NOR flash. The NOR flash data begins with the U-Boot code and is then followed by the Linux code. Finally, the MAC is stored in the last sector. You may need to adjust these settings to your needs. The memory map used to develop the board support is: Memory map: 0x00000000 .. 0x01ffffff SDRAM 0x20000000 .. 0x202fffff NOR flash RAM use: 0x01f9bffc .. 0x01fbbffb U-Boot stack 0x01f9c000 .. 0x01f9ffff U-Boot global data 0x01fa0000 .. 0x01fbffff U-Boot malloc() RAM 0x01fc0000 .. 0x01ffffff U-Boot execution RAM NOR flash use: 0x20000000 .. 0x0002ffff U-Boot 0x20004000 .. 0x20005fff U-Boot environment 0x20030000 .. 0x202effff Linux kernel image 0x202f0000 .. 0x202fffff MAC address sector NOR flash is 0x00300000 (3145728) bytes large (3 MB). Max space for compressed kernel in flash is 0x002c0000 (2883584) bytes (2.75 MB) Max space for u-boot in flash is 0x00030000 (196608) bytes (192 KB) The module is hardwired to BYPASS boot mode.