menu "MIPS architecture"
	depends on MIPS

config SYS_ARCH
	default "mips"

config USE_PRIVATE_LIBGCC
	default y

choice
	prompt "Target select"

config TARGET_QEMU_MIPS
	bool "Support qemu-mips"
	select SUPPORTS_BIG_ENDIAN
	select SUPPORTS_LITTLE_ENDIAN

config TARGET_MALTA
	bool "Support malta"
	select SUPPORTS_BIG_ENDIAN
	select SUPPORTS_LITTLE_ENDIAN

config TARGET_VCT
	bool "Support vct"
	select SUPPORTS_BIG_ENDIAN

config TARGET_DBAU1X00
	bool "Support dbau1x00"
	select SUPPORTS_BIG_ENDIAN
	select SUPPORTS_LITTLE_ENDIAN

config TARGET_PB1X00
	bool "Support pb1x00"
	select SUPPORTS_LITTLE_ENDIAN

config TARGET_QEMU_MIPS64
	bool "Support qemu-mips64"
	select SUPPORTS_BIG_ENDIAN
	select SUPPORTS_LITTLE_ENDIAN

endchoice

source "board/dbau1x00/Kconfig"
source "board/imgtec/malta/Kconfig"
source "board/micronas/vct/Kconfig"
source "board/pb1x00/Kconfig"
source "board/qemu-mips/Kconfig"

if MIPS

choice
	prompt "Endianness selection"
	help
	  Some MIPS boards can be configured for either little or big endian
	  byte order. These modes require different U-Boot images. In general there
	  is one preferred byteorder for a particular system but some systems are
	  just as commonly used in the one or the other endianness.

config SYS_BIG_ENDIAN
	bool "Big endian"
	depends on SUPPORTS_BIG_ENDIAN

config SYS_LITTLE_ENDIAN
	bool "Little endian"
	depends on SUPPORTS_LITTLE_ENDIAN

endchoice

config SUPPORTS_BIG_ENDIAN
	bool

config SUPPORTS_LITTLE_ENDIAN
	bool

endif

endmenu