menu "Panasonic UniPhier platform" depends on ARCH_UNIPHIER config SYS_SOC default "uniphier" config SYS_CONFIG_NAME default "uniphier" config UNIPHIER_SMP bool choice prompt "UniPhier SoC select" config MACH_PH1_PRO4 bool "PH1-Pro4" select UNIPHIER_SMP config MACH_PH1_LD4 bool "PH1-LD4" config MACH_PH1_SLD8 bool "PH1-sLD8" endchoice choice prompt "UniPhier Support Card select" optional config PFC_MICRO_SUPPORT_CARD bool "Support card with PFC CPLD" help This option provides support for the expansion board with PFC original address mapping. Say Y to use the on-board UART, Ether, LED devices. config DCC_MICRO_SUPPORT_CARD bool "Support card with DCC CPLD" help This option provides support for the expansion board with DCC- arranged address mapping that is compatible with legacy UniPhier reference boards. Say Y to use the on-board UART, Ether, LED devices. endchoice config CMD_PINMON bool "Enable boot mode pins monitor command" depends on !SPL_BUILD default y help The command "pinmon" shows the state of the boot mode pins. The boot mode pins are latched when the system reset is deasserted and determine which device the system should load a boot image from. config SOC_INIT bool default SPL_BUILD config DRAM_INIT bool default SPL_BUILD config CMD_DDRPHY_DUMP bool "Enable dump command of DDR PHY parameters" depends on !SPL_BUILD help The command "ddrphy" shows the resulting parameters of DDR PHY training; it is useful for the evaluation of DDR PHY training. choice prompt "DDR3 Frequency select" depends on DRAM_INIT config DDR_FREQ_1600 bool "DDR3 1600" depends on MACH_PH1_PRO4 || MACH_PH1_LD4 config DDR_FREQ_1333 bool "DDR3 1333" depends on MACH_PH1_LD4 || MACH_PH1_SLD8 endchoice config DDR_FREQ int default 1333 if DDR_FREQ_1333 default 1600 if DDR_FREQ_1600 endmenu