From 6e1899e633c2ac3f6da7101d4990361c6ff2a9d2 Mon Sep 17 00:00:00 2001 From: David Mosberger Date: Tue, 6 May 2014 00:46:18 +0530 Subject: mtd: nand: fix GET/SET_FEATURES address on 16-bit devices As per following Sections in ONFI Spec, GET_FEATURES and SET_FEATURES also need byte-addressing on 16-bit devices. *Section: Target Initialization" "The Read ID and Read Parameter Page commands only use the lower 8-bits of the data bus. The host shall not issue commands that use a word data width on x16 devices until the host determines the device supports a 16-bit data bus width in the parameter page." *Section: Bus Width Requirements* "When the host supports a 16-bit bus width, only data is transferred at the 16-bit width. All address and command line transfers shall use only the lower 8-bits of the data bus. During command transfers, the host may place any value on the upper 8-bits of the data bus. During address transfers, the host shall set the upper 8-bits of the data bus to 00h." So porting following commit from linux kernel commit e34fcb07a6d57411de6e15a47724fbe92c5caa42 Author: David Mosberger (preserving authorship) mtd: nand: fix GET/SET_FEATURES address on 16-bit devices Signed-off-by: Pekon Gupta --- include/linux/mtd/nand.h | 11 ++++++++++- 1 file changed, 10 insertions(+), 1 deletion(-) (limited to 'include') diff --git a/include/linux/mtd/nand.h b/include/linux/mtd/nand.h index 4be885823c..991bd8e63e 100644 --- a/include/linux/mtd/nand.h +++ b/include/linux/mtd/nand.h @@ -725,7 +725,16 @@ static inline int onfi_get_sync_timing_mode(struct nand_chip *chip) */ static inline int nand_opcode_8bits(unsigned int command) { - return command == NAND_CMD_READID; + switch (command) { + case NAND_CMD_READID: + case NAND_CMD_PARAM: + case NAND_CMD_GET_FEATURES: + case NAND_CMD_SET_FEATURES: + return 1; + default: + break; + } + return 0; } -- cgit v1.2.1