From 5ec71100dcc7ad58f4b93241d811afa8d19c4c75 Mon Sep 17 00:00:00 2001 From: Masahiro Yamada Date: Mon, 15 Dec 2014 23:26:16 +0900 Subject: mpc8xx: remove IP860 board support This board is still a non-generic board. Signed-off-by: Masahiro Yamada Cc: Wolfgang Denk --- include/commproc.h | 28 ---------------------------- 1 file changed, 28 deletions(-) (limited to 'include/commproc.h') diff --git a/include/commproc.h b/include/commproc.h index 6e0a233e7a..c53482ccce 100644 --- a/include/commproc.h +++ b/include/commproc.h @@ -484,34 +484,6 @@ typedef struct scc_enet { #endif -/*** IP860 **********************************************************/ - -#if defined(CONFIG_IP860) -/* Bits in parallel I/O port registers that have to be set/cleared - * to configure the pins for SCC1 use. - */ -#define PROFF_ENET PROFF_SCC1 -#define CPM_CR_ENET CPM_CR_CH_SCC1 -#define SCC_ENET 0 -#define PA_ENET_RXD ((ushort)0x0001) /* PA 15 */ -#define PA_ENET_TXD ((ushort)0x0002) /* PA 14 */ -#define PA_ENET_RCLK ((ushort)0x0200) /* PA 6 */ -#define PA_ENET_TCLK ((ushort)0x0100) /* PA 7 */ - -#define PC_ENET_TENA ((ushort)0x0001) /* PC 15 */ -#define PC_ENET_CLSN ((ushort)0x0010) /* PC 11 */ -#define PC_ENET_RENA ((ushort)0x0020) /* PC 10 */ - -#define PB_ENET_RESET (uint)0x00000008 /* PB 28 */ -#define PB_ENET_JABD (uint)0x00000004 /* PB 29 */ - -/* Control bits in the SICR to route TCLK (CLK1) and RCLK (CLK2) to - * SCC1. Also, make sure GR1 (bit 24) and SC1 (bit 25) are zero. - */ -#define SICR_ENET_MASK ((uint)0x000000ff) -#define SICR_ENET_CLKRT ((uint)0x0000002C) -#endif /* CONFIG_IP860 */ - /*** KM8XX *********************************************************/ /* The KM8XX Service Module uses SCC3 for Ethernet */ -- cgit v1.2.1