From 69fcb55f71c9e2c40a0f1de6f70b26a9ec02cfb8 Mon Sep 17 00:00:00 2001 From: Amit Virdi Date: Mon, 7 May 2012 13:00:22 +0530 Subject: st_smi: Enhance the error handling This commit does the following: - Reports error if SNOR flash is not found on the board - Changes smi_read_sr to return error using which a retry mechanism is implemented for reading flash status Signed-off-by: Vipin Kumar Signed-off-by: Amit Virdi Signed-off-by: Stefan Roese --- drivers/mtd/st_smi.c | 34 +++++++++++++++++++++------------- 1 file changed, 21 insertions(+), 13 deletions(-) (limited to 'drivers') diff --git a/drivers/mtd/st_smi.c b/drivers/mtd/st_smi.c index 9769b284e7..2c6d59ddbb 100644 --- a/drivers/mtd/st_smi.c +++ b/drivers/mtd/st_smi.c @@ -108,11 +108,17 @@ static ulong flash_get_size(ulong base, int banknum) { flash_info_t *info = &flash_info[banknum]; struct flash_dev *dev; - unsigned int value; + int value; unsigned int density; int i; value = smi_read_id(info, banknum); + + if (value < 0) { + printf("Flash id could not be read\n"); + return 0; + } + density = (value >> 16) & 0xff; for (i = 0, dev = &flash_ids[0]; dev->density != 0x0; @@ -140,7 +146,7 @@ static ulong flash_get_size(ulong base, int banknum) * This routine will get the status register of the flash chip present at the * given bank */ -static unsigned int smi_read_sr(int bank) +static int smi_read_sr(int bank) { u32 ctrlreg1; @@ -174,13 +180,11 @@ static unsigned int smi_read_sr(int bank) */ static int smi_wait_till_ready(int bank, int timeout) { - int count; - unsigned int sr; + int sr; /* One chip guarantees max 5 msec wait here after page writes, but potentially three seconds (!) after page erase. */ - for (count = 0; count < timeout; count++) { - + do { sr = smi_read_sr(bank); if (sr < 0) break; @@ -189,7 +193,8 @@ static int smi_wait_till_ready(int bank, int timeout) /* Try again after 1m-sec */ udelay(1000); - } + } while (timeout--); + printf("SMI controller is still in wait, timeout=%d\n", timeout); return -EIO; } @@ -205,6 +210,7 @@ static int smi_write_enable(int bank) { u32 ctrlreg1; int timeout = WMODE_TOUT; + int sr; /* Store the CTRL REG1 state */ ctrlreg1 = readl(&smicntl->smi_cr1); @@ -221,14 +227,16 @@ static int smi_write_enable(int bank) /* Restore the CTRL REG1 state */ writel(ctrlreg1, &smicntl->smi_cr1); - while (timeout--) { - if (smi_read_sr(bank) & (1 << (bank + WM_SHIFT))) + do { + sr = smi_read_sr(bank); + if (sr < 0) break; - udelay(1000); - } + else if (sr & (1 << (bank + WM_SHIFT))) + return 0; - if (timeout) - return 0; + /* Try again after 1m-sec */ + udelay(1000); + } while (timeout--); return -1; } -- cgit v1.2.1