From a6e50a88d8d3724fc75f1c6959b80a6c7c69cbad Mon Sep 17 00:00:00 2001 From: Ian Campbell Date: Fri, 18 Jul 2014 20:38:41 +0100 Subject: ahci: provide sunxi SATA driver using AHCI platform framework This enables the necessary clocks, in AHB0 and in PLL6_CFG. This is done for sun7i only since I don't have access to any other sunxi platforms with sata included. The PHY setup is derived from the Alwinner releases and Linux, but is mostly undocumented. The Allwinner AHCI controller also requires some magic (and, again, undocumented) DMA initialisation when starting a port. This is added under a suitable ifdef. This option is enabled for Cubieboard, Cubieboard2 and Cubietruck based on contents of Linux DTS files, including SATA power pin config taken from the DTS. All build tested, but runtime tested on Cubieboard2 and Cubietruck only. Signed-off-by: Ian Campbell Acked-by: Hans de Goede Signed-off-by: Hans de Goede --- drivers/block/ahci.c | 16 ++++++++++++++++ 1 file changed, 16 insertions(+) (limited to 'drivers') diff --git a/drivers/block/ahci.c b/drivers/block/ahci.c index 4df804671a..dce99adc6b 100644 --- a/drivers/block/ahci.c +++ b/drivers/block/ahci.c @@ -129,6 +129,14 @@ int __weak ahci_link_up(struct ahci_probe_ent *probe_ent, u8 port) return 1; } +#ifdef CONFIG_SUNXI_AHCI +/* The sunxi AHCI controller requires this undocumented setup */ +static void sunxi_dma_init(volatile u8 *port_mmio) +{ + clrsetbits_le32(port_mmio + PORT_P0DMACR, 0x0000ff00, 0x00004400); +} +#endif + static int ahci_host_init(struct ahci_probe_ent *probe_ent) { #ifndef CONFIG_SCSI_AHCI_PLAT @@ -213,6 +221,10 @@ static int ahci_host_init(struct ahci_probe_ent *probe_ent) msleep(500); } +#ifdef CONFIG_SUNXI_AHCI + sunxi_dma_init(port_mmio); +#endif + /* Add the spinup command to whatever mode bits may * already be on in the command register. */ @@ -545,6 +557,10 @@ static int ahci_port_start(u8 port) writel_with_flush(pp->rx_fis, port_mmio + PORT_FIS_ADDR); +#ifdef CONFIG_SUNXI_AHCI + sunxi_dma_init(port_mmio); +#endif + writel_with_flush(PORT_CMD_ICC_ACTIVE | PORT_CMD_FIS_RX | PORT_CMD_POWER_ON | PORT_CMD_SPIN_UP | PORT_CMD_START, port_mmio + PORT_CMD); -- cgit v1.2.1 From 8d154002f30979c4ef911a3f93e41859bd3beabf Mon Sep 17 00:00:00 2001 From: Roman Byshko Date: Sun, 27 Jul 2014 19:32:44 +0200 Subject: sunxi: add USB EHCI driver The Allwinner aka sunxi SoCs have one or more USB host controllers. This adds a driver for their EHCI. Signed-off-by: Roman Byshko Acked-by: Marek Vasut Signed-off-by: Hans de Goede --- drivers/usb/host/Makefile | 1 + drivers/usb/host/ehci-sunxi.c | 201 ++++++++++++++++++++++++++++++++++++++++++ 2 files changed, 202 insertions(+) create mode 100644 drivers/usb/host/ehci-sunxi.c (limited to 'drivers') diff --git a/drivers/usb/host/Makefile b/drivers/usb/host/Makefile index 04c1a642a3..c4f5157a84 100644 --- a/drivers/usb/host/Makefile +++ b/drivers/usb/host/Makefile @@ -35,6 +35,7 @@ obj-$(CONFIG_USB_EHCI_PPC4XX) += ehci-ppc4xx.o obj-$(CONFIG_USB_EHCI_MARVELL) += ehci-marvell.o obj-$(CONFIG_USB_EHCI_PCI) += ehci-pci.o obj-$(CONFIG_USB_EHCI_SPEAR) += ehci-spear.o +obj-$(CONFIG_USB_EHCI_SUNXI) += ehci-sunxi.o obj-$(CONFIG_USB_EHCI_TEGRA) += ehci-tegra.o obj-$(CONFIG_USB_EHCI_VCT) += ehci-vct.o obj-$(CONFIG_USB_EHCI_RMOBILE) += ehci-rmobile.o diff --git a/drivers/usb/host/ehci-sunxi.c b/drivers/usb/host/ehci-sunxi.c new file mode 100644 index 0000000000..23617b7adc --- /dev/null +++ b/drivers/usb/host/ehci-sunxi.c @@ -0,0 +1,201 @@ +/* + * Copyright (C) 2014 Roman Byshko + * + * Roman Byshko + * + * Based on code from + * Allwinner Technology Co., Ltd. + * + * SPDX-License-Identifier: GPL-2.0+ + */ + +#include +#include +#include +#include +#include "ehci.h" + +#define SUNXI_USB1_IO_BASE 0x01c14000 +#define SUNXI_USB2_IO_BASE 0x01c1c000 + +#define SUNXI_USB_PMU_IRQ_ENABLE 0x800 +#define SUNXI_USB_CSR 0x01c13404 +#define SUNXI_USB_PASSBY_EN 1 + +#define SUNXI_EHCI_AHB_ICHR8_EN (1 << 10) +#define SUNXI_EHCI_AHB_INCR4_BURST_EN (1 << 9) +#define SUNXI_EHCI_AHB_INCRX_ALIGN_EN (1 << 8) +#define SUNXI_EHCI_ULPI_BYPASS_EN (1 << 0) + +static struct sunxi_ehci_hcd { + struct usb_hcd *hcd; + int usb_rst_mask; + int ahb_clk_mask; + int gpio_vbus; + void *csr; + int irq; + int id; +} sunxi_echi_hcd[] = { + { + .usb_rst_mask = CCM_USB_CTRL_PHY1_RST, + .ahb_clk_mask = 1 << AHB_GATE_OFFSET_USB_EHCI0, + .gpio_vbus = CONFIG_SUNXI_USB_VBUS0_GPIO, + .csr = (void *)SUNXI_USB_CSR, + .irq = 39, + .id = 1, + }, +#if (CONFIG_USB_MAX_CONTROLLER_COUNT > 1) + { + .usb_rst_mask = CCM_USB_CTRL_PHY2_RST, + .ahb_clk_mask = 1 << AHB_GATE_OFFSET_USB_EHCI1, + .gpio_vbus = CONFIG_SUNXI_USB_VBUS1_GPIO, + .csr = (void *)SUNXI_USB_CSR, + .irq = 40, + .id = 2, + } +#endif +}; + +static int enabled_hcd_count; + +static void *get_io_base(int hcd_id) +{ + if (hcd_id == 1) + return (void *)SUNXI_USB1_IO_BASE; + else if (hcd_id == 2) + return (void *)SUNXI_USB2_IO_BASE; + else + return NULL; +} + +static void usb_phy_write(struct sunxi_ehci_hcd *sunxi_ehci, int addr, + int data, int len) +{ + int j = 0, usbc_bit = 0; + void *dest = sunxi_ehci->csr; + + usbc_bit = 1 << (sunxi_ehci->id * 2); + for (j = 0; j < len; j++) { + /* set the bit address to be written */ + clrbits_le32(dest, 0xff << 8); + setbits_le32(dest, (addr + j) << 8); + + clrbits_le32(dest, usbc_bit); + /* set data bit */ + if (data & 0x1) + setbits_le32(dest, 1 << 7); + else + clrbits_le32(dest, 1 << 7); + + setbits_le32(dest, usbc_bit); + + clrbits_le32(dest, usbc_bit); + + data >>= 1; + } +} + +static void sunxi_usb_phy_init(struct sunxi_ehci_hcd *sunxi_ehci) +{ + /* The following comments are machine + * translated from Chinese, you have been warned! + */ + + /* adjust PHY's magnitude and rate */ + usb_phy_write(sunxi_ehci, 0x20, 0x14, 5); + + /* threshold adjustment disconnect */ +#ifdef CONFIG_SUN4I + usb_phy_write(sunxi_ehci, 0x2a, 3, 2); +#else + usb_phy_write(sunxi_ehci, 0x2a, 2, 2); +#endif + + return; +} + +static void sunxi_usb_passby(struct sunxi_ehci_hcd *sunxi_ehci, int enable) +{ + unsigned long bits = 0; + void *addr = get_io_base(sunxi_ehci->id) + SUNXI_USB_PMU_IRQ_ENABLE; + + bits = SUNXI_EHCI_AHB_ICHR8_EN | + SUNXI_EHCI_AHB_INCR4_BURST_EN | + SUNXI_EHCI_AHB_INCRX_ALIGN_EN | + SUNXI_EHCI_ULPI_BYPASS_EN; + + if (enable) + setbits_le32(addr, bits); + else + clrbits_le32(addr, bits); + + return; +} + +static void sunxi_ehci_enable(struct sunxi_ehci_hcd *sunxi_ehci) +{ + struct sunxi_ccm_reg *ccm = (struct sunxi_ccm_reg *)SUNXI_CCM_BASE; + + setbits_le32(&ccm->usb_clk_cfg, sunxi_ehci->usb_rst_mask); + setbits_le32(&ccm->ahb_gate0, sunxi_ehci->ahb_clk_mask); + + sunxi_usb_phy_init(sunxi_ehci); + + sunxi_usb_passby(sunxi_ehci, SUNXI_USB_PASSBY_EN); + + gpio_direction_output(sunxi_ehci->gpio_vbus, 1); +} + +static void sunxi_ehci_disable(struct sunxi_ehci_hcd *sunxi_ehci) +{ + struct sunxi_ccm_reg *ccm = (struct sunxi_ccm_reg *)SUNXI_CCM_BASE; + + gpio_direction_output(sunxi_ehci->gpio_vbus, 0); + + sunxi_usb_passby(sunxi_ehci, !SUNXI_USB_PASSBY_EN); + + clrbits_le32(&ccm->ahb_gate0, sunxi_ehci->ahb_clk_mask); + clrbits_le32(&ccm->usb_clk_cfg, sunxi_ehci->usb_rst_mask); +} + +int ehci_hcd_init(int index, enum usb_init_type init, struct ehci_hccr **hccr, + struct ehci_hcor **hcor) +{ + struct sunxi_ccm_reg *ccm = (struct sunxi_ccm_reg *)SUNXI_CCM_BASE; + struct sunxi_ehci_hcd *sunxi_ehci = &sunxi_echi_hcd[index]; + + /* enable common PHY only once */ + if (index == 0) + setbits_le32(&ccm->usb_clk_cfg, CCM_USB_CTRL_PHYGATE); + + sunxi_ehci_enable(sunxi_ehci); + + *hccr = get_io_base(sunxi_ehci->id); + + *hcor = (struct ehci_hcor *)((uint32_t) *hccr + + HC_LENGTH(ehci_readl(&(*hccr)->cr_capbase))); + + debug("sunxi-ehci: init hccr %x and hcor %x hc_length %d\n", + (uint32_t)*hccr, (uint32_t)*hcor, + (uint32_t)HC_LENGTH(ehci_readl(&(*hccr)->cr_capbase))); + + enabled_hcd_count++; + + return 0; +} + +int ehci_hcd_stop(int index) +{ + struct sunxi_ccm_reg *ccm = (struct sunxi_ccm_reg *)SUNXI_CCM_BASE; + struct sunxi_ehci_hcd *sunxi_ehci = &sunxi_echi_hcd[index]; + + sunxi_ehci_disable(sunxi_ehci); + + /* disable common PHY only once, for the last enabled hcd */ + if (enabled_hcd_count == 1) + clrbits_le32(&ccm->usb_clk_cfg, CCM_USB_CTRL_PHYGATE); + + enabled_hcd_count--; + + return 0; +} -- cgit v1.2.1