From 5f93227ce02d9cafa11704c807a80dcbde129f8c Mon Sep 17 00:00:00 2001 From: Soren Brinkmann Date: Fri, 14 Jun 2013 17:43:24 -0700 Subject: fpga: zynqpl: Clear loopback mode during device init Some versions of the Zynq first stage boot loader enable PCAP loopback during boot regardless of whether or not the boot image includes PL configuration. This behavior only appears in certain boot modes (notably QSPI boot). Attempting to configure the PL with the loopback bit set will result in timeouts and will prevent successful configuration. In order to avoid this problem, and to avoid dependency on the version of the FSBL used to boot the system, ensure that the loopback enable bit is cleared when loading the driver. Signed-off-by: Soren Brinkmann Signed-off-by: Michal Simek --- drivers/fpga/zynqpl.c | 4 ++++ 1 file changed, 4 insertions(+) (limited to 'drivers/fpga') diff --git a/drivers/fpga/zynqpl.c b/drivers/fpga/zynqpl.c index aa49e82483..14363c9a5b 100644 --- a/drivers/fpga/zynqpl.c +++ b/drivers/fpga/zynqpl.c @@ -23,6 +23,7 @@ #define DEVCFG_STATUS_DMA_CMD_Q_E 0x40000000 #define DEVCFG_STATUS_DMA_DONE_CNT_MASK 0x30000000 #define DEVCFG_STATUS_PCFG_INIT 0x00000010 +#define DEVCFG_MCTRL_PCAP_LPBK 0x00000010 #define DEVCFG_MCTRL_RFIFO_FLUSH 0x00000002 #define DEVCFG_MCTRL_WFIFO_FLUSH 0x00000001 @@ -200,6 +201,9 @@ int zynq_load(Xilinx_desc *desc, const void *buf, size_t bsize) swap = SWAP_DONE; } + /* Clear loopback bit */ + clrbits_le32(&devcfg_base->mctrl, DEVCFG_MCTRL_PCAP_LPBK); + if (!partialbit) { zynq_slcr_devcfg_disable(); -- cgit v1.2.1