From 04e5ae793153e74d682f2d0e297e58fd75366c8f Mon Sep 17 00:00:00 2001 From: Wolfgang Denk Date: Sun, 11 Sep 2011 21:24:09 +0200 Subject: Minor coding style cleanup. Signed-off-by: Wolfgang Denk --- doc/README.usb | 18 +++++++++--------- 1 file changed, 9 insertions(+), 9 deletions(-) (limited to 'doc/README.usb') diff --git a/doc/README.usb b/doc/README.usb index a8a4058de1..0771c71a85 100644 --- a/doc/README.usb +++ b/doc/README.usb @@ -116,7 +116,7 @@ Bus 002 Device 010: ID 0b95:7720 ASIX Electronics Corp. AX88772 If you look at drivers/usb/eth/asix.c you will see this line within the supported device list, so we know this adapter is supported. - { 0x0b95, 0x7720 }, /* Trendnet TU2-ET100 V3.0R */ + { 0x0b95, 0x7720 }, /* Trendnet TU2-ET100 V3.0R */ If your adapter is not listed there is a still a chance that it will work. Try looking up the manufacturer of the chip inside your adapter. @@ -144,8 +144,8 @@ To enable USB Host Ethernet in U-Boot, your platform must of course support USB with CONFIG_CMD_USB enabled and working. You will need to add some config settings to your board header file: -#define CONFIG_USB_HOST_ETHER /* Enable USB Ethernet adapters */ -#define CONFIG_USB_ETHER_ASIX /* Asix, or whatever driver(s) you want */ +#define CONFIG_USB_HOST_ETHER /* Enable USB Ethernet adapters */ +#define CONFIG_USB_ETHER_ASIX /* Asix, or whatever driver(s) you want */ As with built-in networking, you will also want to enable some network commands, for example: @@ -168,9 +168,9 @@ You can also set the default IP address of your board and the server as well as the default file to load when a 'bootp' command is issued. All of these can be obtained from the bootp server if not set. -#define CONFIG_IPADDR 10.0.0.2 (replace with your value) -#define CONFIG_SERVERIP 10.0.0.1 (replace with your value) -#define CONFIG_BOOTFILE uImage +#define CONFIG_IPADDR 10.0.0.2 (replace with your value) +#define CONFIG_SERVERIP 10.0.0.1 (replace with your value) +#define CONFIG_BOOTFILE uImage The 'usb start' command should identify the adapter something like this: @@ -200,9 +200,9 @@ TFTP from server 172.22.72.144; our IP address is 172.22.73.81 Filename '/tftpboot/uImage-sjg-seaboard-261347'. Load address: 0x40c000 Loading: ################################################################# - ################################################################# - ################################################################# - ################################################ + ################################################################# + ################################################################# + ################################################ done Bytes transferred = 3557464 (364858 hex) CrOS> -- cgit v1.2.1