From c1173bd0754aa55bc52d874d5490c0c892a56ebf Mon Sep 17 00:00:00 2001 From: Eric Nelson Date: Tue, 31 Jan 2012 10:52:07 -0700 Subject: sf command: allow default bus and chip selects This patch allows a board configuration file to provide default bus and chip-selects for SPI flash so that first argument to the 'sf' command is optional. On boards that use the mxc_spi driver and a GPIO for chip select, this allows a much simpler command line: U-Boot> sf probe instead of U-Boot> sf probe 0x5300 Tested-by: Jason Liu Signed-off-by: Eric Nelson Signed-off-by: Mike Frysinger --- common/cmd_sf.c | 37 +++++++++++++++++++++---------------- 1 file changed, 21 insertions(+), 16 deletions(-) (limited to 'common/cmd_sf.c') diff --git a/common/cmd_sf.c b/common/cmd_sf.c index 612fd18617..98e4162114 100644 --- a/common/cmd_sf.c +++ b/common/cmd_sf.c @@ -17,6 +17,12 @@ #ifndef CONFIG_SF_DEFAULT_MODE # define CONFIG_SF_DEFAULT_MODE SPI_MODE_3 #endif +#ifndef CONFIG_SF_DEFAULT_CS +# define CONFIG_SF_DEFAULT_CS 0 +#endif +#ifndef CONFIG_SF_DEFAULT_BUS +# define CONFIG_SF_DEFAULT_BUS 0 +#endif static struct spi_flash *flash; @@ -63,27 +69,26 @@ static int sf_parse_len_arg(char *arg, ulong *len) static int do_spi_flash_probe(int argc, char * const argv[]) { - unsigned int bus = 0; - unsigned int cs; + unsigned int bus = CONFIG_SF_DEFAULT_BUS; + unsigned int cs = CONFIG_SF_DEFAULT_CS; unsigned int speed = CONFIG_SF_DEFAULT_SPEED; unsigned int mode = CONFIG_SF_DEFAULT_MODE; char *endp; struct spi_flash *new; - if (argc < 2) - return -1; - - cs = simple_strtoul(argv[1], &endp, 0); - if (*argv[1] == 0 || (*endp != 0 && *endp != ':')) - return -1; - if (*endp == ':') { - if (endp[1] == 0) - return -1; - - bus = cs; - cs = simple_strtoul(endp + 1, &endp, 0); - if (*endp != 0) + if (argc >= 2) { + cs = simple_strtoul(argv[1], &endp, 0); + if (*argv[1] == 0 || (*endp != 0 && *endp != ':')) return -1; + if (*endp == ':') { + if (endp[1] == 0) + return -1; + + bus = cs; + cs = simple_strtoul(endp + 1, &endp, 0); + if (*endp != 0) + return -1; + } } if (argc >= 3) { @@ -299,7 +304,7 @@ usage: U_BOOT_CMD( sf, 5, 1, do_spi_flash, "SPI flash sub-system", - "probe [bus:]cs [hz] [mode] - init flash device on given SPI bus\n" + "probe [[bus:]cs] [hz] [mode] - init flash device on given SPI bus\n" " and chip select\n" "sf read addr offset len - read `len' bytes starting at\n" " `offset' to memory at `addr'\n" -- cgit v1.2.1