From d5c5132f878394b7487d3f6da0d469aa72737318 Mon Sep 17 00:00:00 2001 From: Stefan Roese Date: Wed, 22 Oct 2014 12:13:11 +0200 Subject: arm: marvell: Extract kirkwood gpio functions into new common file gpio.c This makes is possible to use those gpio functions from other MVEBU SoC's as well. Signed-off-by: Stefan Roese Tested-by: Luka Perkov Acked-by: Prafulla Wadaskar --- board/raidsonic/ib62x0/ib62x0.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) (limited to 'board/raidsonic/ib62x0') diff --git a/board/raidsonic/ib62x0/ib62x0.c b/board/raidsonic/ib62x0/ib62x0.c index 47956b2430..dbcfb43813 100644 --- a/board/raidsonic/ib62x0/ib62x0.c +++ b/board/raidsonic/ib62x0/ib62x0.c @@ -24,9 +24,9 @@ int board_early_init_f(void) * There are maximum 64 gpios controlled through 2 sets of registers * the below configuration configures mainly initial LED status */ - kw_config_gpio(IB62x0_OE_VAL_LOW, - IB62x0_OE_VAL_HIGH, - IB62x0_OE_LOW, IB62x0_OE_HIGH); + mvebu_config_gpio(IB62x0_OE_VAL_LOW, + IB62x0_OE_VAL_HIGH, + IB62x0_OE_LOW, IB62x0_OE_HIGH); /* Set SATA activity LEDs to default off */ writel(MVSATAHC_LED_POLARITY_CTRL, MVSATAHC_LED_CONF_REG); -- cgit v1.2.1