From 36adff362c2c0141ff8a810d42a7e478f779130f Mon Sep 17 00:00:00 2001 From: Stefan Roese Date: Sat, 13 Jan 2007 07:59:19 +0100 Subject: [PATCH] Update Yosemite (440EP) to display board rev and PCI bus speed Now the board revision and the current PCI bus speed are printed after the board message. Also the EBC initialising is now done via defines in the board config file. Signed-off-by: Stefan Roese --- board/amcc/yosemite/yosemite.c | 25 +++++++------------------ 1 file changed, 7 insertions(+), 18 deletions(-) (limited to 'board/amcc/yosemite/yosemite.c') diff --git a/board/amcc/yosemite/yosemite.c b/board/amcc/yosemite/yosemite.c index 588ee900da..d47219cb6f 100644 --- a/board/amcc/yosemite/yosemite.c +++ b/board/amcc/yosemite/yosemite.c @@ -39,24 +39,6 @@ int board_early_init_f(void) reg = mfdcr(ebccfgd); mtdcr(ebccfgd, reg | 0x04000000); /* Set ATC */ - mtebc(pb0ap, 0x03017300); /* FLASH/SRAM */ - mtebc(pb0cr, 0xfc0da000); /* BAS=0xfc0 64MB r/w 16-bit */ - - mtebc(pb1ap, 0x00000000); - mtebc(pb1cr, 0x00000000); - - mtebc(pb2ap, 0x04814500); - /*CPLD*/ mtebc(pb2cr, 0x80018000); /*BAS=0x800 1MB r/w 8-bit */ - - mtebc(pb3ap, 0x00000000); - mtebc(pb3cr, 0x00000000); - - mtebc(pb4ap, 0x00000000); - mtebc(pb4cr, 0x00000000); - - mtebc(pb5ap, 0x00000000); - mtebc(pb5cr, 0x00000000); - /*-------------------------------------------------------------------- * Setup the GPIO pins *-------------------------------------------------------------------*/ @@ -186,8 +168,15 @@ int misc_init_r (void) int checkboard(void) { char *s = getenv("serial#"); + u8 rev; + u8 val; printf("Board: Yosemite - AMCC PPC440EP Evaluation Board"); + + rev = *(u8 *)(CFG_CPLD + 0); + val = *(u8 *)(CFG_CPLD + 5) & 0x01; + printf(", Rev. %X, PCI=%d MHz", rev, val ? 66 : 33); + if (s != NULL) { puts(", serial# "); puts(s); -- cgit v1.2.1