From 207b7b2c9d9752e0f6478c30c29b7087f6e6cbb6 Mon Sep 17 00:00:00 2001 From: Wolfgang Denk Date: Mon, 7 May 2007 22:07:08 +0200 Subject: Get rid of duplicated file (see doc/README.SBC8560 instead) Signed-off-by: Wolfgang Denk --- doc/README.sbc8560 | 53 ----------------------------------------------------- 1 file changed, 53 deletions(-) delete mode 100644 doc/README.sbc8560 diff --git a/doc/README.sbc8560 b/doc/README.sbc8560 deleted file mode 100644 index 52592e3f41..0000000000 --- a/doc/README.sbc8560 +++ /dev/null @@ -1,53 +0,0 @@ -The port was tested on Wind River System Sbc8560 board . -U-Boot was installed on the flash memory of the CPU card (no the SODIMM). - -NOTE: Please configure uboot compile to the proper PCI frequency and -setup the appropriate DIP switch settings. - -SBC8560 board: - -Make sure boards switches are set to their appropriate conditions. -Refer to the Engineering Reference Guide ERG-00300-002. Of particular -importance are: 1)Tthe settings for JP4 (JP4 1-3 and 2-4), which -select the on-board FLASH device (Intel 28F128Jx); 2) The settings -for the Clock SW9 (33 MHz or 66 MHz). - - Note: SW9 Settings: 66 MHz - 4:1 ratio CCB clocks:SYSCLK - 3:1 ration e500 Core:CCB - pos1 - on, pos2 - on, pos3 - off, pos4 - on, pos5 - off, pos6 - on - Note: SW9 Settings: 33 MHz - 8:1 ratio CCB clocks:SYSCLK - 3:1 ration e500 Core:CCB - pos1 - on, pos2 - on, pos3 - on, pos4 - off, pos5 - off, pos6 - on - - -Flashing the FLASH device with the "Wind River ICE": - -1) Properly connect and configure the Wind River ICE to the - target JTAG port. This includes running the SBC8560 register script. - Make sure target memory can be read and written. - -2) Build the u-boot image: - make distclean - make SBC8560_66_config or SBC8560_33_config - make CROSS_COMPILE=.../ELDK3.0/ppc_8xx-/ all - - Note: reference is made to the ELDK3.0 compiler but any 85xx cross-compiler - should suffice. - -3) Convert the uboot (.elf) file to a uboot.bin file (using visionClick converter). - The bin file should be converted from fffc0000 to ffffffff - -4) Setup the Flash Utility (tools menu) for: - - Determine the clock speed of the PCI bus and set SW9 accordingly - Note: the speed of the PCI bus defaults to the slowest PCI card - PlayBack the "default" register file for the SBC8560 - Select the uboot.bin file with zero bias - Select the initialize Target prior to programming - Select the V28F640Jx (8192 x 8) 1 device FLASH Algorithm - Select the erase base address from FFFC0000 to FFFFFFFF - Select the start address from 0 with size of 4000 - -5) Erase and Program -- cgit v1.2.1