summaryrefslogtreecommitdiffstats
path: root/include/configs/galaxy5200.h
Commit message (Collapse)AuthorAgeFilesLines
* galaxy5200: Add default environment variablesEric Millbrandt2009-10-281-2/+8
| | | | | | | Extend bootdelay to 10 seconds. Set boot retry time to 120 seconds and use reset to retry. Define default bootcommand and bootargs for production. Signed-off-by: Eric Millbrandt <emillbrandt@dekaresearch.com>
* galaxy5200: change cs1 configurationEric Millbrandt2009-10-181-1/+1
| | | | | | Correct the chip select configuration for the nand flash chip select. Signed-off-by: Eric Millbrandt <emillbrandt@dekaresearch.com>
* galaxy5200: enable version environment variableEric Millbrandt2009-09-241-0/+2
| | | | | | | | | | | Add version environment variable configuration to the galaxy5200 board header file. Signed-off-by: Eric Millbrandt <emillbrandt@dekaresearch.com> Edited commit message. Signed-off-by: Wolfgang Denk <wd@denx.de>
* Reset i2c slave devices during init on mpc5xxx cpusEric Millbrandt2009-09-061-0/+1
| | | | | | | | | | | Reset any i2c devices that may have been interrupted during a system reset. Normally this would be accomplished by clocking the line until SCL and SDA are released and then sending a start condtiion (From an Atmel datasheet). There is no direct access to the i2c pins so instead create start commands through the i2c interface. Send a start command then delay for the SDA Hold time, repeat this by disabling/enabling the bus a total of 9 times. Signed-off-by: Eric Millbrandt <emillbrandt@dekaresearch.com>
* galaxy5200: Add chip select region for an Epson S1D15313Eric Millbrandt2009-09-041-0/+5
| | | | Signed-off-by: Eric Millbrandt <emillbrandt@dekaresearch.com>
* galaxy5200: Cleanup typo and trailing whitespaceEric Millbrandt2009-08-261-4/+4
| | | | Signed-off-by: Eric Millbrandt <emillbrandt@dekaresearch.com>
* Add support for the galaxy5200Eric Millbrandt2009-08-251-0/+428
Add support for the DEKA Research and Development galaxy5200 board The galaxy5200 is an Freescale mpc5200 based embedded industrial control board. Signed-off-by: Eric Millbrandt <emillbrandt@dekaresearch.com>
OpenPOWER on IntegriCloud