diff options
Diffstat (limited to 'board/ti')
-rw-r--r-- | board/ti/ks2_evm/README | 10 |
1 files changed, 5 insertions, 5 deletions
diff --git a/board/ti/ks2_evm/README b/board/ti/ks2_evm/README index 6586faba32..b8247256e9 100644 --- a/board/ti/ks2_evm/README +++ b/board/ti/ks2_evm/README @@ -61,7 +61,7 @@ Supported image formats: - u-boot.bin: for loading and running u-boot.bin through Texas instruments code composure studio (CCS) - u-boot-spi.gph: gpimage for programming SPI NOR flash for SPI NOR boot - - u-boot-nand.gph: gpimage for programming AEMIF NAND flash for NAND boot + - MLO: gpimage for programming AEMIF NAND flash for NAND boot Build instructions: =================== @@ -76,9 +76,9 @@ To build u-boot-spi.gph >make k2hk_evm_defconfig >make u-boot-spi.gph -To build u-boot-nand.gph +To build MLO >make k2hk_evm_defconfig - >make u-boot-nand.gph + >make MLO Load and Run U-Boot on keystone EVMs using CCS ========================================= @@ -157,12 +157,12 @@ instructions: 1. Start CCS and run U-boot as described above. 2. Suspend Target. Select Run -> Suspend from top level menu CortexA15_1 (Free Running)" -3. Load u-boot-nand.gph binary from build folder on to DDR address 0x87000000 +3. Load MLO binary from build folder on to DDR address 0x87000000 through CCS as described in step 2 of "Load and Run U-Boot on K2HK EVM using CCS", but using address 0x87000000. 4. Free Run the target as described earlier (step 4) to get u-boot prompt 5. At the U-Boot console type following to setup u-boot environment variables. - setenv filesize <size in hex of u-boot-nand.gph rounded to hex 0x10000> + setenv filesize <size in hex of MLO rounded to hex 0x10000> run burn_uboot_nand Once u-boot prompt is available, Power OFF the EVM. Set the SW1 dip switch to "ARM NAND Boot mode" as per instruction at |