diff options
Diffstat (limited to 'board/sbc8548/ddr.c')
-rw-r--r-- | board/sbc8548/ddr.c | 77 |
1 files changed, 77 insertions, 0 deletions
diff --git a/board/sbc8548/ddr.c b/board/sbc8548/ddr.c index 996ffe206d..45ec485c50 100644 --- a/board/sbc8548/ddr.c +++ b/board/sbc8548/ddr.c @@ -7,6 +7,7 @@ */ #include <common.h> +#include <i2c.h> #include <asm/fsl_ddr_sdram.h> #include <asm/fsl_ddr_dimm_params.h> @@ -54,3 +55,79 @@ void fsl_ddr_board_options(memctl_options_t *popts, */ popts->half_strength_driver_enable = 0; } + +#ifdef CONFIG_SPD_EEPROM +/* + * Workaround for hardware errata. An i2c address conflict + * existed on earlier boards; the workaround moved the DDR + * SPD from 0x51 to 0x53. So we try and read 0x53 1st, and + * if that fails, then fall back to reading at 0x51. + */ +void get_spd(generic_spd_eeprom_t *spd, u8 i2c_address) +{ + int ret; + +#ifdef ALT_SPD_EEPROM_ADDRESS + if (i2c_address == SPD_EEPROM_ADDRESS) { + ret = i2c_read(ALT_SPD_EEPROM_ADDRESS, 0, 1, (uchar *)spd, + sizeof(generic_spd_eeprom_t)); + if (ret == 0) + return; /* Good data at 0x53 */ + memset(spd, 0, sizeof(generic_spd_eeprom_t)); + } +#endif + ret = i2c_read(i2c_address, 0, 1, (uchar *)spd, + sizeof(generic_spd_eeprom_t)); + if (ret) { + printf("DDR: failed to read SPD from addr %u\n", i2c_address); + memset(spd, 0, sizeof(generic_spd_eeprom_t)); + } +} + +#else +/* + * fixed_sdram init -- doesn't use serial presence detect. + * Assumes 256MB DDR2 SDRAM SODIMM, without ECC, running at DDR400 speed. + */ +phys_size_t fixed_sdram(void) +{ + volatile ccsr_ddr_t *ddr = (void *)(CONFIG_SYS_MPC85xx_DDR_ADDR); + + out_be32(&ddr->cs0_bnds, 0x0000007f); + out_be32(&ddr->cs1_bnds, 0x008000ff); + out_be32(&ddr->cs2_bnds, 0x00000000); + out_be32(&ddr->cs3_bnds, 0x00000000); + + out_be32(&ddr->cs0_config, 0x80010101); + out_be32(&ddr->cs1_config, 0x80010101); + out_be32(&ddr->cs2_config, 0x00000000); + out_be32(&ddr->cs3_config, 0x00000000); + + out_be32(&ddr->timing_cfg_3, 0x00000000); + out_be32(&ddr->timing_cfg_0, 0x00220802); + out_be32(&ddr->timing_cfg_1, 0x38377322); + out_be32(&ddr->timing_cfg_2, 0x0fa044C7); + + out_be32(&ddr->sdram_cfg, 0x4300C000); + out_be32(&ddr->sdram_cfg_2, 0x24401000); + + out_be32(&ddr->sdram_mode, 0x23C00542); + out_be32(&ddr->sdram_mode_2, 0x00000000); + + out_be32(&ddr->sdram_interval, 0x05080100); + out_be32(&ddr->sdram_md_cntl, 0x00000000); + out_be32(&ddr->sdram_data_init, 0x00000000); + out_be32(&ddr->sdram_clk_cntl, 0x03800000); + asm("sync;isync;msync"); + udelay(500); + + #ifdef CONFIG_DDR_ECC + /* Enable ECC checking */ + out_be32(&ddr->sdram_cfg, CONFIG_SYS_DDR_CONTROL | 0x20000000); + #else + out_be32(&ddr->sdram_cfg, CONFIG_SYS_DDR_CONTROL); + #endif + + return CONFIG_SYS_SDRAM_SIZE * 1024 * 1024; +} +#endif |