diff options
Diffstat (limited to 'board/LEOX/elpt860/elpt860.c')
| -rw-r--r-- | board/LEOX/elpt860/elpt860.c | 52 |
1 files changed, 26 insertions, 26 deletions
diff --git a/board/LEOX/elpt860/elpt860.c b/board/LEOX/elpt860/elpt860.c index 5f506314c5..905df92b1d 100644 --- a/board/LEOX/elpt860/elpt860.c +++ b/board/LEOX/elpt860/elpt860.c @@ -138,23 +138,23 @@ const uint sdram_table[] = { /* ------------------------------------------------------------------------- */ -#define CFG_PC4 0x0800 +#define CONFIG_SYS_PC4 0x0800 -#define CFG_DS1 CFG_PC4 +#define CONFIG_SYS_DS1 CONFIG_SYS_PC4 /* * Very early board init code (fpga boot, etc.) */ int board_early_init_f (void) { - volatile immap_t *immr = (immap_t *) CFG_IMMR; + volatile immap_t *immr = (immap_t *) CONFIG_SYS_IMMR; /* * Light up the red led on ELPT860 pcb (DS1) (PCDAT) */ - immr->im_ioport.iop_pcdat &= ~CFG_DS1; /* PCDAT (DS1 = 0) */ - immr->im_ioport.iop_pcpar &= ~CFG_DS1; /* PCPAR (0=general purpose I/O) */ - immr->im_ioport.iop_pcdir |= CFG_DS1; /* PCDIR (I/O: 0=input, 1=output) */ + immr->im_ioport.iop_pcdat &= ~CONFIG_SYS_DS1; /* PCDAT (DS1 = 0) */ + immr->im_ioport.iop_pcpar &= ~CONFIG_SYS_DS1; /* PCPAR (0=general purpose I/O) */ + immr->im_ioport.iop_pcdir |= CONFIG_SYS_DS1; /* PCDIR (I/O: 0=input, 1=output) */ return (0); /* success */ } @@ -181,7 +181,7 @@ int checkboard (void) phys_size_t initdram (int board_type) { - volatile immap_t *immap = (immap_t *) CFG_IMMR; + volatile immap_t *immap = (immap_t *) CONFIG_SYS_IMMR; volatile memctl8xx_t *memctl = &immap->im_memctl; long int size8, size9; long int size_b0 = 0; @@ -207,7 +207,7 @@ phys_size_t initdram (int board_type) * with two SDRAM banks or four cycles every 31.2 us with one * bank. It will be adjusted after memory sizing. */ - memctl->memc_mptpr = CFG_MPTPR_2BK_8K; + memctl->memc_mptpr = CONFIG_SYS_MPTPR_2BK_8K; /* * The following value is used as an address (i.e. opcode) for @@ -229,10 +229,10 @@ phys_size_t initdram (int board_type) * preliminary addresses - these have to be modified after the * SDRAM size has been determined. */ - memctl->memc_or1 = CFG_OR1_PRELIM; - memctl->memc_br1 = CFG_BR1_PRELIM; + memctl->memc_or1 = CONFIG_SYS_OR1_PRELIM; + memctl->memc_br1 = CONFIG_SYS_BR1_PRELIM; - memctl->memc_mamr = CFG_MAMR_8COL & (~(MAMR_PTAE)); /* no refresh yet */ + memctl->memc_mamr = CONFIG_SYS_MAMR_8COL & (~(MAMR_PTAE)); /* no refresh yet */ udelay (200); @@ -252,7 +252,7 @@ phys_size_t initdram (int board_type) * * try 8 column mode */ - size8 = dram_size (CFG_MAMR_8COL, + size8 = dram_size (CONFIG_SYS_MAMR_8COL, SDRAM_BASE1_PRELIM, SDRAM_MAX_SIZE); udelay (1000); @@ -260,7 +260,7 @@ phys_size_t initdram (int board_type) /* * try 9 column mode */ - size9 = dram_size (CFG_MAMR_9COL, + size9 = dram_size (CONFIG_SYS_MAMR_9COL, SDRAM_BASE1_PRELIM, SDRAM_MAX_SIZE); if (size8 < size9) { /* leave configuration at 9 columns */ @@ -269,7 +269,7 @@ phys_size_t initdram (int board_type) } else { /* back to 8 columns */ size_b0 = size8; - memctl->memc_mamr = CFG_MAMR_8COL; + memctl->memc_mamr = CONFIG_SYS_MAMR_8COL; udelay (500); /* debug ("SDRAM Bank 0 in 8 column mode: %ld MB\n", size >> 20); */ } @@ -282,22 +282,22 @@ phys_size_t initdram (int board_type) */ if (size_b0 < 0x02000000) { /* reduce to 15.6 us (62.4 us / quad) */ - memctl->memc_mptpr = CFG_MPTPR_2BK_4K; + memctl->memc_mptpr = CONFIG_SYS_MPTPR_2BK_4K; udelay (1000); } /* * Final mapping: map bigger bank first */ - memctl->memc_or1 = ((-size_b0) & 0xFFFF0000) | CFG_OR_TIMING_SDRAM; - memctl->memc_br1 = (CFG_SDRAM_BASE & BR_BA_MSK) | BR_MS_UPMA | BR_V; + memctl->memc_or1 = ((-size_b0) & 0xFFFF0000) | CONFIG_SYS_OR_TIMING_SDRAM; + memctl->memc_br1 = (CONFIG_SYS_SDRAM_BASE & BR_BA_MSK) | BR_MS_UPMA | BR_V; { unsigned long reg; /* adjust refresh rate depending on SDRAM type, one bank */ reg = memctl->memc_mptpr; - reg >>= 1; /* reduce to CFG_MPTPR_1BK_8K / _4K */ + reg >>= 1; /* reduce to CONFIG_SYS_MPTPR_1BK_8K / _4K */ memctl->memc_mptpr = reg; } @@ -319,7 +319,7 @@ phys_size_t initdram (int board_type) static long int dram_size (long int mamr_value, long int *base, long int maxsize) { - volatile immap_t *immap = (immap_t *) CFG_IMMR; + volatile immap_t *immap = (immap_t *) CONFIG_SYS_IMMR; volatile memctl8xx_t *memctl = &immap->im_memctl; memctl->memc_mamr = mamr_value; @@ -329,20 +329,20 @@ dram_size (long int mamr_value, long int *base, long int maxsize) /* ------------------------------------------------------------------------- */ -#define CFG_PA1 0x4000 -#define CFG_PA2 0x2000 +#define CONFIG_SYS_PA1 0x4000 +#define CONFIG_SYS_PA2 0x2000 -#define CFG_LBKs (CFG_PA2 | CFG_PA1) +#define CONFIG_SYS_LBKs (CONFIG_SYS_PA2 | CONFIG_SYS_PA1) void reset_phy (void) { - volatile immap_t *immr = (immap_t *) CFG_IMMR; + volatile immap_t *immr = (immap_t *) CONFIG_SYS_IMMR; /* * Ensure LBK LXT901 ethernet 1 & 2 = 0 ... for normal loopback in effect * and no AUI loopback */ - immr->im_ioport.iop_padat &= ~CFG_LBKs; /* PADAT (LBK eth 1&2 = 0) */ - immr->im_ioport.iop_papar &= ~CFG_LBKs; /* PAPAR (0=general purpose I/O) */ - immr->im_ioport.iop_padir |= CFG_LBKs; /* PADIR (I/O: 0=input, 1=output) */ + immr->im_ioport.iop_padat &= ~CONFIG_SYS_LBKs; /* PADAT (LBK eth 1&2 = 0) */ + immr->im_ioport.iop_papar &= ~CONFIG_SYS_LBKs; /* PAPAR (0=general purpose I/O) */ + immr->im_ioport.iop_padir |= CONFIG_SYS_LBKs; /* PADIR (I/O: 0=input, 1=output) */ } |
