diff options
| -rw-r--r-- | README | 11 | ||||
| -rw-r--r-- | drivers/mtd/spi/sf_internal.h | 4 | ||||
| -rw-r--r-- | drivers/mtd/spi/sf_probe.c | 30 |
3 files changed, 0 insertions, 45 deletions
@@ -3086,17 +3086,6 @@ CBFS (Coreboot Filesystem) support memories can be connected with a given cs line. Currently Xilinx Zynq qspi supports these type of connections. - CONFIG_SYS_SPI_ST_ENABLE_WP_PIN - enable the W#/Vpp signal to disable writing to the status - register on ST MICRON flashes like the N25Q128. - The status register write enable/disable bit, combined with - the W#/VPP signal provides hardware data protection for the - device as follows: When the enable/disable bit is set to 1, - and the W#/VPP signal is driven LOW, the status register - nonvolatile bits become read-only and the WRITE STATUS REGISTER - operation will not execute. The only way to exit this - hardware-protected mode is to drive W#/VPP HIGH. - - SystemACE Support: CONFIG_SYSTEMACE diff --git a/drivers/mtd/spi/sf_internal.h b/drivers/mtd/spi/sf_internal.h index 785f7a96fe..bd834dc263 100644 --- a/drivers/mtd/spi/sf_internal.h +++ b/drivers/mtd/spi/sf_internal.h @@ -97,10 +97,6 @@ enum { #define STATUS_QEB_MXIC (1 << 6) #define STATUS_PEC (1 << 7) -#ifdef CONFIG_SYS_SPI_ST_ENABLE_WP_PIN -#define STATUS_SRWD (1 << 7) /* SR write protect */ -#endif - /* Flash timeout values */ #define SPI_FLASH_PROG_TIMEOUT (2 * CONFIG_SYS_HZ) #define SPI_FLASH_PAGE_ERASE_TIMEOUT (5 * CONFIG_SYS_HZ) diff --git a/drivers/mtd/spi/sf_probe.c b/drivers/mtd/spi/sf_probe.c index 2ee228d3f3..de8d0b7f7c 100644 --- a/drivers/mtd/spi/sf_probe.c +++ b/drivers/mtd/spi/sf_probe.c @@ -288,34 +288,6 @@ int spi_flash_decode_fdt(const void *blob, struct spi_flash *flash) } #endif /* CONFIG_OF_CONTROL */ -#ifdef CONFIG_SYS_SPI_ST_ENABLE_WP_PIN -/* enable the W#/Vpp signal to disable writing to the status register */ -static int spi_enable_wp_pin(struct spi_flash *flash) -{ - u8 status; - int ret; - - ret = spi_flash_cmd_read_status(flash, &status); - if (ret < 0) - return ret; - - ret = spi_flash_cmd_write_status(flash, STATUS_SRWD); - if (ret < 0) - return ret; - - ret = spi_flash_cmd_write_disable(flash); - if (ret < 0) - return ret; - - return 0; -} -#else -static int spi_enable_wp_pin(struct spi_flash *flash) -{ - return 0; -} -#endif - /** * spi_flash_probe_slave() - Probe for a SPI flash device on a bus * @@ -394,8 +366,6 @@ int spi_flash_probe_slave(struct spi_slave *spi, struct spi_flash *flash) puts(" Full access #define CONFIG_SPI_FLASH_BAR\n"); } #endif - if (spi_enable_wp_pin(flash)) - puts("Enable WP pin failed\n"); /* Release spi bus */ spi_release_bus(spi); |
