| Commit message (Collapse) | Author | Age | Files | Lines |
|---|
| |
|
|
|
|
|
|
| |
These flags are now always passed to all tests and need to be disabled if
not needed. Disabling these flags, rather than passing them to almost all
tests, significantly simplfies our RUN: lines.
llvm-svn: 249422
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
As we do not rely on ScalarEvolution any more we do not need to get
the backedge taken count. Additionally, our domain generation handles
everything that is affine and has one latch and our ScopDetection will
over-approximate everything else.
This change will therefor allow loops with:
- one latch
- exiting conditions that are affine
Additionally, it will not check for structured control flow anymore.
Hence, loops and conditionals are not necessarily single entry single
exit regions any more.
Differential Version: http://reviews.llvm.org/D12758
llvm-svn: 247289
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Instead of flat schedules, we now use so-called schedule trees to represent the
execution order of the statements in a SCoP. Schedule trees make it a lot easier
to analyze, understand and modify properties of a schedule, as specific nodes
in the tree can be choosen and possibly replaced.
This patch does not yet fully move our DependenceInfo pass to schedule trees,
as some additional performance analysis is needed here. (In general schedule
trees should be faster in compile-time, as the more structured representation
is generally easier to analyze and work with). We also can not yet perform the
reduction analysis on schedule trees.
For more information regarding schedule trees, please see Section 6 of
https://lirias.kuleuven.be/handle/123456789/497238
llvm-svn: 242130
|
| |
|
|
|
|
|
|
| |
I just learned that target triples prevent test cases to be run on other
architectures. Polly test cases are until now sufficiently target independent
to not require any target triples. Hence, we drop them.
llvm-svn: 235384
|
| |
|
|
| |
llvm-svn: 230796
|
| |
|
|
| |
llvm-svn: 230784
|
| |
|
|
|
|
|
|
|
|
| |
Scops that only read seem generally uninteresting and scops that only write are
most likely initializations where there is also little to optimize. To not
waste compile time we bail early.
Differential Revision: http://reviews.llvm.org/D7735
llvm-svn: 229820
|
| |
|
|
|
|
|
|
|
| |
Schedule dimensions that have the same constant value accross all statements do
not carry any information, but due to the increased dimensionality of the
schedule cost compile time. To not pay this cost, we remove constant dimensions
if possible.
llvm-svn: 225067
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
This replaces the use of %defaultOpts = '-basicaa -polly-prepare' with the
minimal set of passes necessary for a test to succeed. Of the test cases that
previously used %defaultOpts 76 test cases require none of these passes, 42
need -basicaa and only 2 need -polly-prepare. Our change makes this requirement
explicit.
In Polly many test cases have been using a macro '%defaultOpts' which run a
couple of preparing passes before the actual Polly test case. This macro was
introduced very early in the development of Polly and originally contained a
large set of canonicalization passes. However, as the need for additional
canonicalization passes makes test cases harder to understand and also more
fragile in terms of changes in such passes, we aim since a longer time to only
include the minimal set of passes necessary. This patch removes the last
leftovers from of %defaultOpts and brings our tests cases more in line to what
is usus in LLVM itself.
llvm-svn: 216815
|
| |
|
|
|
|
|
|
|
| |
Use the fact that if we visit a for node first in pre and next in post order
we know we did not visit any children, thus we found an innermost loop.
+ Test case for an innermost loop with a conditional inside
llvm-svn: 213870
|
|
|
llvm-svn: 169161
|
