diff options
Diffstat (limited to 'docs/manual')
| -rw-r--r-- | docs/manual/adding-packages-autotools.txt | 2 | ||||
| -rw-r--r-- | docs/manual/faq-troubleshooting.txt | 8 |
2 files changed, 5 insertions, 5 deletions
diff --git a/docs/manual/adding-packages-autotools.txt b/docs/manual/adding-packages-autotools.txt index ece6c49563..a041d91eb6 100644 --- a/docs/manual/adding-packages-autotools.txt +++ b/docs/manual/adding-packages-autotools.txt @@ -125,7 +125,7 @@ cases, typical packages will therefore only use a few of them. variables to pass to the 'autoreconf' program if +LIBFOO_AUTORECONF=YES+. These are passed in the environment of the 'autoreconf' command. By default, empty. - + * +LIBFOO_AUTORECONF_OPTS+ to specify additional options passed to the 'autoreconf' program if +LIBFOO_AUTORECONF=YES+. By default, empty. diff --git a/docs/manual/faq-troubleshooting.txt b/docs/manual/faq-troubleshooting.txt index 693028c4da..b30b4ac43c 100644 --- a/docs/manual/faq-troubleshooting.txt +++ b/docs/manual/faq-troubleshooting.txt @@ -19,10 +19,10 @@ Starting dropbear sshd: generating rsa key... generating dsa key... OK then it means that your system is running, but didn't start a shell on the serial console. In order to have the system start a shell on your -serial console, you have to go into the Buildroot configuration, in -+System configuration+, modify +Run a getty (login prompt) after boot+ -and set the appropriate port and baud rate in the +getty options+ -submenu. This will automatically tune the +/etc/inittab+ file of the +serial console, you have to go into the Buildroot configuration, in ++System configuration+, modify +Run a getty (login prompt) after boot+ +and set the appropriate port and baud rate in the +getty options+ +submenu. This will automatically tune the +/etc/inittab+ file of the generated system so that a shell starts on the correct serial port. [[faq-no-compiler-on-target]] |
